Skip to contentSkip to conversation

rtl8xxxu: add bluetooth co-existence support for single antenna

PATCH In review Chris Chiu 3 participants 3 messages Oct 5, 2019 – Oct 9, 2019

Subsystems (3)
lore
Share & tools
lore

Chris Chiu

author
#0 lore raw

PATCH v3 1/1 rtl8xxxu: add bluetooth co-existence support for single antenna

The RTL8723BU suffers the wifi disconnection problem while bluetooth device connected. While wifi is doing tx/rx, the bluetooth will scan without results. This is due to the wifi and bluetooth share the same single antenna for RF communication and they need to have a mechanism to collaborate.

BT information is provided via the packet sent from co-processor to host (C2H). It contains the status of BT but the rtl8723bu_handle_c2h dose not really handle it. And there's no bluetooth coexistence mechanism to deal with it.

This commit adds a workqueue to set the tdma configurations and coefficient table per the parsed bluetooth link status and given wifi connection state. The tdma/coef table comes from the vendor driver code of the RTL8192EU and RTL8723BU. However, this commit is only for single antenna scenario which RTL8192EU is default dual antenna. The rtl8xxxu_parse_rxdesc24 which invokes the handle_c2h is only for 8723b and 8192e so the mechanism is expected to work on both chips with single antenna. Note RTL8192EU dual antenna is not supported.

---

Notes:
v2:
- Add helper functions to replace bunch of tdma settings
- Reformat some lines to meet kernel coding style
v3:
- Add comment for rtl8723bu_set_coex_with_type()

 .../net/wireless/realtek/rtl8xxxu/rtl8xxxu.h  |  37 +++
 .../realtek/rtl8xxxu/rtl8xxxu_8723b.c         |   2 -
 .../wireless/realtek/rtl8xxxu/rtl8xxxu_core.c | 269 +++++++++++++++++-
 3 files changed, 301 insertions(+), 7 deletions(-)
drivers/net/wireless/realtek/rtl8xxxu/rtl8xxxu.h +37 -0
index 582c2a346cec..22e95b11bfbb 100644
@@ -1220,6 +1220,37 @@ enum ratr_table_mode_new {
 	RATEID_IDX_BGN_3SS = 14,
 };
 
+#define BT_INFO_8723B_1ANT_B_FTP		BIT(7)
+#define BT_INFO_8723B_1ANT_B_A2DP		BIT(6)
+#define BT_INFO_8723B_1ANT_B_HID		BIT(5)
+#define BT_INFO_8723B_1ANT_B_SCO_BUSY		BIT(4)
+#define BT_INFO_8723B_1ANT_B_ACL_BUSY		BIT(3)
+#define BT_INFO_8723B_1ANT_B_INQ_PAGE		BIT(2)
+#define BT_INFO_8723B_1ANT_B_SCO_ESCO		BIT(1)
+#define BT_INFO_8723B_1ANT_B_CONNECTION	BIT(0)
+
+enum _BT_8723B_1ANT_STATUS {
+	BT_8723B_1ANT_STATUS_NON_CONNECTED_IDLE      = 0x0,
+	BT_8723B_1ANT_STATUS_CONNECTED_IDLE          = 0x1,
+	BT_8723B_1ANT_STATUS_INQ_PAGE                = 0x2,
+	BT_8723B_1ANT_STATUS_ACL_BUSY                = 0x3,
+	BT_8723B_1ANT_STATUS_SCO_BUSY                = 0x4,
+	BT_8723B_1ANT_STATUS_ACL_SCO_BUSY            = 0x5,
+	BT_8723B_1ANT_STATUS_MAX
+};
+
+struct rtl8xxxu_btcoex {
+	u8      bt_status;
+	bool	bt_busy;
+	bool	has_sco;
+	bool	has_a2dp;
+	bool    has_hid;
+	bool    has_pan;
+	bool	hid_only;
+	bool	a2dp_only;
+	bool    c2h_bt_inquiry;
+};
+
 #define RTL8XXXU_RATR_STA_INIT 0
 #define RTL8XXXU_RATR_STA_HIGH 1
 #define RTL8XXXU_RATR_STA_MID  2
@@ -1340,6 +1371,10 @@ struct rtl8xxxu_priv {
 	 */
 	struct ieee80211_vif *vif;
 	struct delayed_work ra_watchdog;
+	struct work_struct c2hcmd_work;
+	struct sk_buff_head c2hcmd_queue;
+	spinlock_t c2hcmd_lock;
+	struct rtl8xxxu_btcoex bt_coex;
 };
 
 struct rtl8xxxu_rx_urb {
@@ -1486,6 +1521,8 @@ void rtl8xxxu_fill_txdesc_v2(struct ieee80211_hw *hw, struct ieee80211_hdr *hdr,
 			     struct rtl8xxxu_txdesc32 *tx_desc32, bool sgi,
 			     bool short_preamble, bool ampdu_enable,
 			     u32 rts_rate);
+void rtl8723bu_set_ps_tdma(struct rtl8xxxu_priv *priv,
+			   u8 arg1, u8 arg2, u8 arg3, u8 arg4, u8 arg5);
 
 extern struct rtl8xxxu_fileops rtl8192cu_fops;
 extern struct rtl8xxxu_fileops rtl8192eu_fops;
drivers/net/wireless/realtek/rtl8xxxu/rtl8xxxu_8723b.c +0 -2
index ceffe05bd65b..9ba661b3d767 100644
@@ -1580,9 +1580,7 @@ static void rtl8723b_enable_rf(struct rtl8xxxu_priv *priv)
 	/*
 	 * Software control, antenna at WiFi side
 	 */
-#ifdef NEED_PS_TDMA
 	rtl8723bu_set_ps_tdma(priv, 0x08, 0x00, 0x00, 0x00, 0x00);
-#endif
 
 	rtl8xxxu_write32(priv, REG_BT_COEX_TABLE1, 0x55555555);
 	rtl8xxxu_write32(priv, REG_BT_COEX_TABLE2, 0x55555555);
drivers/net/wireless/realtek/rtl8xxxu/rtl8xxxu_core.c +264 -5

311 lines not on this page · raw message

Signature · 1 line
2.20.1
maintainer
#1 lore raw
Quoted 22 lines · Chris Chiu

The RTL8723BU suffers the wifi disconnection problem while bluetooth device connected. While wifi is doing tx/rx, the bluetooth will scan without results. This is due to the wifi and bluetooth share the same single antenna for RF communication and they need to have a mechanism to collaborate.

BT information is provided via the packet sent from co-processor to host (C2H). It contains the status of BT but the rtl8723bu_handle_c2h dose not really handle it. And there's no bluetooth coexistence mechanism to deal with it.

This commit adds a workqueue to set the tdma configurations and coefficient table per the parsed bluetooth link status and given wifi connection state. The tdma/coef table comes from the vendor driver code of the RTL8192EU and RTL8723BU. However, this commit is only for single antenna scenario which RTL8192EU is default dual antenna. The rtl8xxxu_parse_rxdesc24 which invokes the handle_c2h is only for 8723b and 8192e so the mechanism is expected to work on both chips with single antenna. Note RTL8192EU dual antenna is not supported.

Quoted 8 lines

---

Notes:
v2:
- Add helper functions to replace bunch of tdma settings
- Reformat some lines to meet kernel coding style
v3:
- Add comment for rtl8723bu_set_coex_with_type()

Looks good to me!

Jes

#2 lore raw
In reply to Chris Chiu
Quoted 21 lines · Chris Chiu

The RTL8723BU suffers the wifi disconnection problem while bluetooth device connected. While wifi is doing tx/rx, the bluetooth will scan without results. This is due to the wifi and bluetooth share the same single antenna for RF communication and they need to have a mechanism to collaborate.

BT information is provided via the packet sent from co-processor to host (C2H). It contains the status of BT but the rtl8723bu_handle_c2h dose not really handle it. And there's no bluetooth coexistence mechanism to deal with it.

This commit adds a workqueue to set the tdma configurations and coefficient table per the parsed bluetooth link status and given wifi connection state. The tdma/coef table comes from the vendor driver code of the RTL8192EU and RTL8723BU. However, this commit is only for single antenna scenario which RTL8192EU is default dual antenna. The rtl8xxxu_parse_rxdesc24 which invokes the handle_c2h is only for 8723b and 8192e so the mechanism is expected to work on both chips with single antenna. Note RTL8192EU dual antenna is not supported.

Quoted 2 lines

Patch applied to wireless-drivers-next.git, thanks.

e542e66b7c2e rtl8xxxu: add bluetooth co-existence support for single antenna

Signature · 3 lines
https://patchwork.kernel.org/patch/11175575/

https://wireless.wiki.kernel.org/en/developers/documentation/submittingpatches