ath11k: avoid burst time conversion logic
PATCH 1/1 ath11k: avoid burst time conversion logic
WMI_VDEV_SET_WMM_PARAMS commmand expects the txoplimit param in the units of 32 microseconds. convert the txop unit from 32 microseconds to absolute microseconds leads to the higher burst values which is incorrect. so no need to convert the txop unit from 32 microseconds to absolute microseconds.
--- drivers/net/wireless/ath/ath11k/mac.c | 7 +------ 1 file changed, 1 insertion(+), 6 deletions(-)
drivers/net/wireless/ath/ath11k/mac.c +1 -6
@@ -3023,12 +3023,7 @@ static int ath11k_mac_op_conf_tx(struct ieee80211_hw *hw, p->cwmin = params->cw_min; p->cwmax = params->cw_max; p->aifs = params->aifs; - -/* The channel time duration programmed in the HW is in absolute -* microseconds, while mac80211 gives the txop in units of -* 32 microseconds. -*/ - p->txop = params->txop *32 ; + p->txop = params->txop; ret =ath11k_wmi_send_wmm_update_cmd_tlv (ar, arvif->vdev_id, &arvif->wmm_params);
Signature · 7 lines
1.9.1 _______________________________________________ ath11k mailing list [email protected] http://lists.infradead.org/mailman/listinfo/ath11k
Quoted 7 lines · Karthikeyan Periyasamy
WMI_VDEV_SET_WMM_PARAMScommmand expects the txoplimit param in the units of 32 microseconds. convert the txop unit from 32 microseconds to absolute microseconds leads to the higher burst values which is incorrect. so no need to convert the txop unit from 32 microseconds to absolute microseconds.Signed-off-by Karthikeyan Periyasamy <[email protected]>Signed-off-by Kalle Valo <[email protected]>
Patch applied to ath11k-post-bringup branch of ath.git, thanks.
ecbd15739034 ath11k: avoid burst time conversion logic
Signature · 9 lines
https://patchwork.kernel.org/patch/11219119/ https://wireless.wiki.kernel.org/en/developers/documentation/submittingpatches _______________________________________________ ath11k mailing list [email protected] http://lists.infradead.org/mailman/listinfo/ath11k