Kconfig: ti: Make board detect EEPROM addresses depend BOARD_DETECT
PATCH 1/1 Kconfig: ti: Make board detect EEPROM addresses depend BOARD_DETECT
There is an option to enable the board detection for TI platforms. If this is option is not set, there is no reason to set the EEPROM bus address or chip address.
This patch makes both EEPROM_BUS_ADDRESS and EEPROM_CHIP_ADDRESS depend on TI_I2C_BOARD_DETECT.
Signed-off-by Adam Ford <[email protected]>
board/ti/common/Kconfig +2 -0
@@ -8,11 +8,13 @@ config EEPROM_BUS_ADDRESS int "Board EEPROM's I2C bus address" range 0 8 default 0 + depends on TI_I2C_BOARD_DETECT config EEPROM_CHIP_ADDRESS hex "Board EEPROM's I2C chip address" range 0 0xff default 0x50 + depends on TI_I2C_BOARD_DETECT config TI_COMMON_CMD_OPTIONS bool "Enable cmd options on TI platforms"
Signature · 1 line
2.20.1
PATCH 1/1 Kconfig: ti: Make board detect EEPROM addresses depend BOARD_DETECT
board/ti/common/Kconfig
Quoted 11 lines · Adam Ford
There is an option to enable the board detection for TI platforms. If this is option is not set, there is no reason to set the EEPROM bus address or chip address.
This patch makes both
EEPROM_BUS_ADDRESSandEEPROM_CHIP_ADDRESSdepend onTI_I2C_BOARD_DETECT.Signed-off-by Adam Ford <[email protected]>board/ti/common/Kconfig +0
-0
Applied to u-boot/master, thanks!
Signature · 8 lines
Tom -------------- next part -------------- A non-text attachment was scrubbed... Name: signature.asc Type: application/pgp-signature Size: 833 bytes Desc: not available URL: <http://lists.denx.de/pipermail/u-boot/attachments/20191108/42b61d7f/attachment.sig>