Bluetooth: btusb: Edit the logical value for Realtek Bluetooth reset
Subsystems (2)
PATCH 1/1 Bluetooth: btusb: Edit the logical value for Realtek Bluetooth reset
From: Max Chou <[email protected]>
It should be pull low and pull high on the physical line for the Realtek Bluetooth reset. gpiod_set_value_cansleep() takes ACTIVE_LOW status for the logical value settings, so the original commit should be corrected.
Signed-off-by Max Chou <[email protected]>
--- drivers/bluetooth/btusb.c | 4 ++-- 1 file changed, 2 insertions(+), 2 deletions(-)
drivers/bluetooth/btusb.c +2 -2
@@ -552,9 +552,9 @@ static void btusb_rtl_cmd_timeout(struct hci_dev *hdev) }bt_dev_err (hdev,"Reset Realtek device via gpio" ); -gpiod_set_value_cansleep (reset_gpio,0 ); -msleep (200 );gpiod_set_value_cansleep (reset_gpio,1 ); +msleep (200 ); +gpiod_set_value_cansleep (reset_gpio,0 ); }static inline void btusb_free_frags (struct btusb_data *data)
Signature · 7 lines
2.17.1 _______________________________________________ linux-arm-kernel mailing list [email protected] http://lists.infradead.org/mailman/listinfo/linux-arm-kernel
Marcel Holtmann
maintainerHi Max,
Quoted 8 lines
It should be pull low and pull high on the physical line for the Realtek Bluetooth reset.
gpiod_set_value_cansleep()takesACTIVE_LOWstatus for the logical value settings, so the original commit should be corrected.Signed-off-by Max Chou <[email protected]>---
drivers/bluetooth/btusb.c| 4 ++--1 file changed, 2 insertions(+), 2 deletions(-)
patch has been applied to bluetooth-next tree.
Regards
Marcel