bluetooth: hci_bcm: enable IRQ capability from node
PATCH 1/1 bluetooth: hci_bcm: enable IRQ capability from node
Actually IRQ can be found from GPIO but all platorms don't support gpiod_to_irq, it's the case on amlogic chip.
so to have possibility to use interrupt mode we need to add interrupts field in node and support it in driver.
Signed-off-by Guillaume La Roque <[email protected]>
--- drivers/bluetooth/hci_bcm.c | 3 +++ 1 file changed, 3 insertions(+)
drivers/bluetooth/hci_bcm.c +3 -0
@@ -1372,6 +1372,7 @@ static struct platform_driver bcm_driver = {static int bcm_serdev_probe (struct serdev_device *serdev) {struct bcm_device *bcmdev; +struct platform_device *pdev;int err; bcmdev =devm_kzalloc (&serdev->dev,sizeof (*bcmdev),GFP_KERNEL );
@@ -1384,6 +1385,8 @@ static int bcm_serdev_probe(struct serdev_device *serdev)#endif bcmdev->serdev_hu.serdev = serdev;serdev_device_set_drvdata (serdev, bcmdev); + pdev =to_platform_device (bcmdev->dev); + bcmdev->irq =platform_get_irq (pdev,0 );if (has_acpi_companion (&serdev->dev)) err =bcm_acpi_probe (bcmdev);
Signature · 1 line
2.17.1