MediaTek UFS vendor implemenation part III and Auto-Hibern8 fix
Subsystems (2)
v2 cover MediaTek UFS vendor implemenation part III and Auto-Hibern8 fix
Hi,
This series provides MediaTek vendor implementations and some general fixes.
- General fixes
- Fix Auto-Hibern8 error detection
- MediaTek vendor implementations
- Ensure UniPro is powered on before every link startup
- Support linkoff state during suspend
- Gate reference clock for Auto-Hibern8 case
v1 -> v2
- Fix and refine commit messages.
Stanley Chu (5):
scsi: ufs-mediatek: ensure UniPro is not powered down before linkup
scsi: ufs-mediatek: support linkoff state during suspend
scsi: ufs: add ufshcd_is_auto_hibern8_enabled facility
scsi: ufs: fix auto-hibern8 error detection
scsi: ufs-mediatek: gate ref-clk during Auto-Hibern8
drivers/scsi/ufs/ufs-mediatek.c | 65 +++++++++++++++++++++------------ drivers/scsi/ufs/ufs-mediatek.h | 12 ++++++ drivers/scsi/ufs/ufshcd.c | 3 +- drivers/scsi/ufs/ufshcd.h | 6 +++ 4 files changed, 62 insertions(+), 24 deletions(-)
Signature · 1 line
2.18.0
PATCH v2 1/5 scsi: ufs-mediatek: ensure UniPro is not powered down before linkup
MediaTek Chipsets can enter proprietary UniPro low-power mode during suspend while link is in hibern8 state. Make sure leaving low-power mode before every link startup to prevent lockup in any possible error recovery path.
In the same time, re-factor related funcitons to improve code readability.
--- drivers/scsi/ufs/ufs-mediatek.c | 19 ++++++++++--------- 1 file changed, 10 insertions(+), 9 deletions(-)
drivers/scsi/ufs/ufs-mediatek.c +10 -9
@@ -30,6 +30,11 @@#define ufs_mtk_device_reset_ctrl (high, res) \ ufs_mtk_smc(UFS_MTK_SIP_DEVICE_RESET, high, res) +#define ufs_mtk_unipro_powerdown (hba, powerdown) \ + ufshcd_dme_set(hba, \ + UIC_ARG_MIB_SEL(VS_UNIPROPOWERDOWNCONTROL, 0), \ + powerdown) +static void ufs_mtk_cfg_unipro_cg (struct ufs_hba *hba,bool enable) {u32 tmp;
@@ -290,6 +295,8 @@ static int ufs_mtk_pre_link(struct ufs_hba *hba)int ret;u32 tmp; +ufs_mtk_unipro_powerdown (hba,0 ); +/* disable deep stall */ ret =ufshcd_dme_get (hba,UIC_ARG_MIB (VS_SAVEPOWERCONTROL ), &tmp);if (ret)
@@ -390,9 +397,7 @@ static int ufs_mtk_link_set_hpm(struct ufs_hba *hba)if (err)return err; - err =ufshcd_dme_set (hba, -UIC_ARG_MIB_SEL (VS_UNIPROPOWERDOWNCONTROL ,0 ), -0 ); + err =ufs_mtk_unipro_powerdown (hba,0 );if (err)return err;
@@ -413,14 +418,10 @@ static int ufs_mtk_link_set_lpm(struct ufs_hba *hba) {int err; - err =ufshcd_dme_set (hba, -UIC_ARG_MIB_SEL (VS_UNIPROPOWERDOWNCONTROL ,0 ), -1 ); + err =ufs_mtk_unipro_powerdown (hba,1 );if (err) {/* Resume UniPro state for following error recovery */ -ufshcd_dme_set (hba, -UIC_ARG_MIB_SEL (VS_UNIPROPOWERDOWNCONTROL ,0 ), -0 ); +ufs_mtk_unipro_powerdown (hba,0 );return err; }
Signature · 1 line
2.18.0
PATCH v2 2/5 scsi: ufs-mediatek: support linkoff state during suspend
In reply to Stanley ChuIf system suspend or runtime suspend mode is configured as linkoff state, phy can be powered off and reference clock can be gated in MediaTek Chipsets.
In the same time, remove redundant reference clock control in suspend and resume callbacks because such control can be well-handled in setup_clocks callback..
--- drivers/scsi/ufs/ufs-mediatek.c | 12 +++++++----- 1 file changed, 7 insertions(+), 5 deletions(-)
drivers/scsi/ufs/ufs-mediatek.c +7 -5
@@ -167,7 +167,7 @@ static int ufs_mtk_setup_clocks(struct ufs_hba *hba, bool on,switch (status) {case PRE_CHANGE : -if (!on) { +if (!on && !ufshcd_is_link_active (hba)) {ufs_mtk_setup_ref_clk (hba, on); ret =phy_power_off (host->mphy); }
@@ -437,10 +437,11 @@ static int ufs_mtk_suspend(struct ufs_hba *hba, enum ufs_pm_op pm_op) err =ufs_mtk_link_set_lpm (hba);if (err)return -EAGAIN ; -phy_power_off (host->mphy); -ufs_mtk_setup_ref_clk (hba, false); } +if (!ufshcd_is_link_active (hba)) +phy_power_off (host->mphy); +return 0 ; }
@@ -449,9 +450,10 @@ static int ufs_mtk_resume(struct ufs_hba *hba, enum ufs_pm_op pm_op)struct ufs_mtk_host *host =ufshcd_get_variant (hba);int err; -if (ufshcd_is_link_hibern8 (hba)) { -ufs_mtk_setup_ref_clk (hba, true); +if (!ufshcd_is_link_active (hba))phy_power_on (host->mphy); + +if (ufshcd_is_link_hibern8 (hba)) { err =ufs_mtk_link_set_hpm (hba);if (err)return err;
Signature · 1 line
2.18.0
PATCH v2 3/5 scsi: ufs: add ufshcd_is_auto_hibern8_enabled facility
In reply to Stanley ChuAuto-Hibern8 may be disabled by some vendors or sysfs in runtime even if Auto-Hibern8 capability is supported by host. Thus provide a way to detect if Auto-Hibern8 is actually enabled for future related handlings.
--- drivers/scsi/ufs/ufshcd.h | 6 ++++++ 1 file changed, 6 insertions(+)
drivers/scsi/ufs/ufshcd.h +6 -0
@@ -55,6 +55,7 @@#include <linux/clk.h> #include <linux/completion.h> #include <linux/regulator/consumer.h> +#include <linux/bitfield.h> #include "unipro.h" #include <asm/irq.h>
@@ -773,6 +774,11 @@ static inline bool ufshcd_is_auto_hibern8_supported(struct ufs_hba *hba)return (hba->capabilities &MASK_AUTO_HIBERN8_SUPPORT ); } +static inline bool ufshcd_is_auto_hibern8_enabled (struct ufs_hba *hba) +{ +return FIELD_GET (UFSHCI_AHIBERN8_TIMER_MASK , hba->ahit) ? true : false; +} +#define ufshcd_writel (hba, val, reg) \ writel((val), (hba)->mmio_base + (reg))#define ufshcd_readl (hba, reg) \
Signature · 1 line
2.18.0
RE: [EXT] [PATCH v2 3/5] scsi: ufs: add ufshcd_is_auto_hibern8_enabled facility
Quoted 1 line
Signed-off-by Stanley Chu <[email protected]>
PATCH v2 4/5 scsi: ufs: fix auto-hibern8 error detection
In reply to Stanley ChuIf Auto-Hibern8 capability is supported by host but not actually enabled, Auto-Hibern8 error shall not happen. Thus bypass Auto-Hibern8 disabling case in ufshcd_is_auto_hibern8_error().
--- drivers/scsi/ufs/ufshcd.c | 3 ++- 1 file changed, 2 insertions(+), 1 deletion(-)
drivers/scsi/ufs/ufshcd.c +2 -1
@@ -5479,7 +5479,8 @@ static irqreturn_t ufshcd_update_uic_error(struct ufs_hba *hba)static bool ufshcd_is_auto_hibern8_error (struct ufs_hba *hba,u32 intr_mask) { -if (!ufshcd_is_auto_hibern8_supported (hba)) +if (!ufshcd_is_auto_hibern8_supported (hba) || + !ufshcd_is_auto_hibern8_enabled (hba))return false;if (!(intr_mask &UFSHCD_UIC_HIBERN8_MASK ))
Signature · 1 line
2.18.0
RE: [EXT] [PATCH v2 4/5] scsi: ufs: fix auto-hibern8 error detection
Hi, Stanley
Do you think it is necessary to add fixes tag, and combine this patch with previous patch to single patch? That will be easier to down port to the older kernel.
Quoted 2 lines
Signed-off-by Stanley Chu <[email protected]>
_______________________________________________
linux-arm-kernel mailing list
[email protected]
http://lists.infradead.org/mailman/listinfo/linux-arm-kernel
RE: [EXT] [PATCH v2 4/5] scsi: ufs: fix auto-hibern8 error detection
Hi Bean,
Quoted 3 lines · Bean Huo (beanhuo)
Hi, Stanley
Do you think it is necessary to add fixes tag, and combine this patch with previous patch to single patch? That will be easier to down port to the older kernel.
OK! I will update this patch according to your suggestions in next version.
Thanks,
Stanley
PATCH v2 5/5 scsi: ufs-mediatek: gate ref-clk during Auto-Hibern8
In reply to Stanley ChuIn current UFS driver design, hba->uic_link_state will not be changed after link enters Hibern8 state by Auto-Hibern8 mechanism. In this case, reference clock gating will be skipped unless special handling is implemented in vendor's callbacks.
Support reference clock gating during Auto-Hibern8 period in MediaTek Chipsets: If link state is already in Hibern8 while Auto-Hibern8 feature is enabled, gate reference clock in setup_clocks callback.
--- drivers/scsi/ufs/ufs-mediatek.c | 38 +++++++++++++++++++++++---------- drivers/scsi/ufs/ufs-mediatek.h | 12 +++++++++++ 2 files changed, 39 insertions(+), 11 deletions(-)
drivers/scsi/ufs/ufs-mediatek.c +27 -11
@@ -143,6 +143,17 @@ static int ufs_mtk_setup_ref_clk(struct ufs_hba *hba, bool on)return 0 ; } +static u32 ufs_mtk_link_get_state (struct ufs_hba *hba) +{ +u32 val; + +ufshcd_writel (hba,0x20 ,REG_UFS_DEBUG_SEL ); + val =ufshcd_readl (hba,REG_UFS_PROBE ); + val = val >>28 ; + +return val; +} +/** * ufs_mtk_setup_clocks - enables/disable clocks * @hba: host controller instance
@@ -155,7 +166,7 @@ static int ufs_mtk_setup_clocks(struct ufs_hba *hba, bool on, enum ufs_notify_change_status status) {struct ufs_mtk_host *host =ufshcd_get_variant (hba); -int ret = -EINVAL ; +int ret =0 ;/* * In case ufs_mtk_init() is not yet done, simply ignore.
@@ -165,19 +176,24 @@ static int ufs_mtk_setup_clocks(struct ufs_hba *hba, bool on,if (!host)return 0 ; -switch (status) { -case PRE_CHANGE : -if (!on && !ufshcd_is_link_active (hba)) { +if (!on && status ==PRE_CHANGE ) { +if (!ufshcd_is_link_active (hba)) {ufs_mtk_setup_ref_clk (hba, on); ret =phy_power_off (host->mphy); + }else { +/* +* Gate ref-clk if link state is in Hibern8 +* triggered by Auto-Hibern8. +*/ +if (!ufshcd_can_hibern8_during_gating (hba) && +ufshcd_is_auto_hibern8_enabled (hba) && +ufs_mtk_link_get_state (hba) == +VS_LINK_HIBER8 ) +ufs_mtk_setup_ref_clk (hba, on); } -break ; -case POST_CHANGE : -if (on) { - ret =phy_power_on (host->mphy); -ufs_mtk_setup_ref_clk (hba, on); - } -break ; + }else if (on && status ==POST_CHANGE ) { + ret =phy_power_on (host->mphy); +ufs_mtk_setup_ref_clk (hba, on); }return ret;
drivers/scsi/ufs/ufs-mediatek.h +12 -0
@@ -53,6 +53,18 @@#define VS_SAVEPOWERCONTROL 0xD0A6#define VS_UNIPROPOWERDOWNCONTROL 0xD0A8 +/* +* Vendor specific link state +*/ +enum { +VS_LINK_DISABLED =0 , +VS_LINK_DOWN =1 , +VS_LINK_UP =2 , +VS_LINK_HIBER8 =3 , +VS_LINK_LOST =4 , +VS_LINK_CFG =5 , +}; +/* * SiP commands */
Signature · 1 line
2.18.0