mmotm 2020-02-19-19-51 uploaded

   http://www.ozlabs.org/~akpm/mmotm/
~Randy
Reported-by: Randy Dunlap <[email protected]>
# end of IRQ subsystem
# end of Timers subsystem
# end of CPU/Task time and stats accounting
# end of RCU Subsystem
# end of Scheduler features
# end of Kernel Performance Events And Counters
# end of General setup
# end of Performance monitoring
# end of Processor type and features
# end of CPU Frequency scaling
# end of CPU Idle
# end of Power management and ACPI options
# end of Bus options (PCI etc.)
# end of Binary Emulations
# end of Tegra firmware driver
# end of Firmware Drivers
# end of GCOV-based kernel profiling
# end of General architecture-dependent options
# end of Partition Types
# end of IO Schedulers
# end of Executable file formats
# end of Memory Management options
# end of Network testing
# end of Networking options
# end of AX.25 network device drivers
# end of CAN Device Drivers
# end of Bluetooth device drivers
# end of Near Field Communication (NFC) devices
# end of DesignWare PCI Core Support
# end of Cadence PCIe controllers support
# end of PCI controller drivers
# end of PCI Endpoint
# end of PCI switch controller drivers
# end of Firmware loader
# end of Generic Driver Options
# end of Bus devices
# end of Partition parsers
# end of RAM/ROM/Flash chip drivers
# end of Mapping drivers for chip access
# end of Self-contained MTD device drivers
# end of LPDDR & LPDDR2 PCM memory drivers
# end of NVME Support
# end of EEPROM support
# end of Texas Instruments shared transport line discipline
# end of Intel MIC & related support
# end of Misc devices
# end of SCSI Transports
# end of SCSI device support
# end of IEEE 1394 (FireWire) support
# end of Hardware I/O ports
# end of Input device support
# end of PCMCIA character devices
# end of Character devices
# end of Multiplexer I2C Chip support
# end of I2C Hardware Bus support
# end of I2C support
# end of PTP clock support
# end of Memory mapped GPIO drivers
# end of Port-mapped I/O GPIO drivers
# end of I2C GPIO expanders
# end of MFD GPIO expanders
# end of PCI GPIO expanders
# end of USB GPIO expanders
# end of 1-wire Bus Masters
# end of 1-wire Slaves
# end of ACPI INT340X thermal drivers
# end of Intel thermal drivers
# end of STMicroelectronics STMPE Interface Drivers
# end of Multifunction device drivers
# end of I2C Encoders, decoders, sensors and other helper chips
# end of SPI helper chips
# end of Customize TV tuners
# end of Customise DVB Frontends
# end of I2C encoder or helper chips
# end of ARM devices
# end of ACP (Audio CoProcessor) Configuration
# drm/i915 Debugging
#
CONFIG_DRM_I915_WERROR=y
CONFIG_DRM_I915_DEBUG=y
CONFIG_DRM_I915_DEBUG_MMIO=y
# CONFIG_DRM_I915_DEBUG_GEM is not set
CONFIG_DRM_I915_SW_FENCE_DEBUG_OBJECTS=y
# CONFIG_DRM_I915_SW_FENCE_CHECK_DAG is not set
# CONFIG_DRM_I915_DEBUG_GUC is not set
CONFIG_DRM_I915_SELFTEST=y
CONFIG_DRM_I915_LOW_LEVEL_TRACEPOINTS=y
CONFIG_DRM_I915_DEBUG_VBLANK_EVADE=y
CONFIG_DRM_I915_DEBUG_RUNTIME_PM=y
# end of drm/i915 Debugging
# drm/i915 Profile Guided Optimisation
#
CONFIG_DRM_I915_USERFAULT_AUTOSUSPEND=250
CONFIG_DRM_I915_HEARTBEAT_INTERVAL=2500
CONFIG_DRM_I915_PREEMPT_TIMEOUT=640
CONFIG_DRM_I915_SPIN_REQUEST=5
CONFIG_DRM_I915_STOP_TIMEOUT=100
CONFIG_DRM_I915_TIMESLICE_DURATION=1
# end of drm/i915 Profile Guided Optimisation
# end of Display Panels
# end of Display Interface Bridges
# end of Frame buffer Devices
# end of Backlight & LCD device support
# end of Graphics support
# end of Special HID drivers
# end of USB HID Boot Protocol drivers
# end of USB HID support
# end of I2C HID support
# end of Intel ISH HID support
# end of HID support
# also be needed; see USB_STORAGE Help for more info
#
# CONFIG_USB_STORAGE is not set
# end of USB Physical Layer drivers
# end of USB Peripheral Controller
# end of USB Type-C Multiplexer/DeMultiplexer Switch support
# end of USB Type-C Alternate Mode drivers
# iptables trigger is under Netfilter config (LED target)
#
CONFIG_LEDS_TRIGGER_TRANSIENT=y
# CONFIG_LEDS_TRIGGER_CAMERA is not set
CONFIG_LEDS_TRIGGER_PANIC=y
CONFIG_LEDS_TRIGGER_NETDEV=y
# CONFIG_LEDS_TRIGGER_PATTERN is not set
# CONFIG_LEDS_TRIGGER_AUDIO is not set
# CONFIG_ACCESSIBILITY is not set
CONFIG_EDAC_ATOMIC_SCRUB=y
CONFIG_EDAC_SUPPORT=y
# CONFIG_EDAC is not set
CONFIG_RTC_LIB=y
CONFIG_RTC_MC146818_LIB=y
# CONFIG_RTC_CLASS is not set
CONFIG_DMADEVICES=y
# CONFIG_DMADEVICES_DEBUG is not set
# end of DMABUF options
# end of Microsoft Hyper-V guest support
# end of Speakup console speech
# end of Android
# end of Gasket devices
# end of Intel Speed Select Technology interface support
# end of Common Clock Framework
# end of Clock Source drivers
# end of Generic IOMMU Pagetable Support
# end of Remoteproc drivers
# end of Rpmsg drivers
# end of Amlogic SoC drivers
# end of Aspeed SoC drivers
# end of Broadcom SoC drivers
# end of NXP/Freescale QorIQ SoC drivers
# end of i.MX SoC drivers
# end of Qualcomm SoC drivers
# end of Xilinx SoC drivers
# end of SOC (System On Chip) specific Drivers
# end of IRQ chip support
# end of PHY Subsystem
# end of Performance monitor support
# end of Android
# end of HW tracing support
# end of TEE drivers
# end of Multiplexer drivers
# end of Device Drivers
# end of Caches
# end of CD-ROM/DVD Filesystems
# end of DOS/FAT/NT Filesystems
# end of Pseudo filesystems
# end of File systems
# end of Memory initialization
# end of Kernel hardening options
# end of Security options
# end of Certificates for signature checking
# end of Library routines
# printk and dmesg options
#
CONFIG_PRINTK_TIME=y
# CONFIG_PRINTK_CALLER is not set
CONFIG_CONSOLE_LOGLEVEL_DEFAULT=7
CONFIG_CONSOLE_LOGLEVEL_QUIET=4
CONFIG_MESSAGE_LOGLEVEL_DEFAULT=4
CONFIG_DEBUG_SYNCHRO_TEST=y
# CONFIG_BOOT_PRINTK_DELAY is not set
# CONFIG_DYNAMIC_DEBUG is not set
# CONFIG_SYMBOLIC_ERRNAME is not set
CONFIG_DEBUG_BUGVERBOSE=y
# end of printk and dmesg options
# end of Compile-time checks and compiler options
# end of Generic Kernel Debugging Instruments
# end of Memory Debugging
# end of Debug Oops, Lockups and Hangs
# end of Scheduler Debugging
# end of Lock Debugging (spinlocks, mutexes, etc...)
# end of Debug kernel data structures
# end of RCU Debugging
# x86 Debugging
#
# CONFIG_DEBUG_AID_FOR_SYZBOT is not set
CONFIG_TRACE_IRQFLAGS_SUPPORT=y
CONFIG_EARLY_PRINTK_USB=y
CONFIG_X86_VERBOSE_BOOTUP=y
CONFIG_EARLY_PRINTK=y
CONFIG_EARLY_PRINTK_DBGP=y
CONFIG_EARLY_PRINTK_USB_XDBC=y
# CONFIG_DEBUG_WX is not set
CONFIG_DOUBLEFAULT=y
# CONFIG_DEBUG_TLBFLUSH is not set
# CONFIG_IOMMU_DEBUG is not set
CONFIG_HAVE_MMIOTRACE_SUPPORT=y
CONFIG_X86_DECODER_SELFTEST=y
# CONFIG_IO_DELAY_0X80 is not set
# CONFIG_IO_DELAY_0XED is not set
# CONFIG_IO_DELAY_UDELAY is not set
CONFIG_IO_DELAY_NONE=y
# CONFIG_DEBUG_BOOT_PARAMS is not set
CONFIG_CPA_DEBUG=y
CONFIG_DEBUG_ENTRY=y
CONFIG_DEBUG_NMI_SELFTEST=y
CONFIG_X86_DEBUG_FPU=y
CONFIG_PUNIT_ATOM_DEBUG=y
# CONFIG_UNWINDER_ORC is not set
CONFIG_UNWINDER_FRAME_POINTER=y
# end of x86 Debugging
# end of Kernel Testing and Coverage
# end of Kernel hacking
   http://www.ozlabs.org/~akpm/mmotm/
index b314d44ded5e..bc28c31c4f78 100644
@@ -301,7 +301,7 @@ extra-$(CONFIG_DRM_I915_WERROR) += \
 		$(shell cd $(srctree)/$(src) && find * -name '*.h')))
 
 quiet_cmd_hdrtest = HDRTEST $(patsubst %.hdrtest,%.h,$@)
-      cmd_hdrtest = $(CC) $(c_flags) -S -o /dev/null -x c /dev/null -include $<; touch $@
+      cmd_hdrtest = $(CC) $(filter-out $(CFLAGS_GCOV), $(c_flags)) -S -o /dev/null -x c /dev/null -include $<; touch $@
 
 $(obj)/%.hdrtest: $(src)/%.h FORCE
 	$(call if_changed_dep,hdrtest)

Jani Nikula, Intel Open Source Graphics Center
$ dim checkpatch origin/drm-tip
df38073c0873 mmotm 2020-02-19-19-51 uploaded (gpu/drm/i915/ + HDRTEST)
-:29: WARNING:COMMIT_LOG_LONG_LINE: Possible unwrapped commit description (prefer a maximum 75 chars per line)
#29: 

mmotm 2020-02-19-19-51 uploaded

[email protected]

Randy Dunlap

Jani Nikula

Patchwork

Patchwork

Patchwork