scsi: ufs: add error recovery for suspend and resume in ufs-mediatek
Subsystems (2)
v3 cover scsi: ufs: add error recovery for suspend and resume in ufs-mediatek
Hi,
This patchset adds error recovery flow for suspend and resume in ufs-mediatek driver.
v2 -> v3:
- Fix commit messages (Avri Altman)
v1 -> v2:
- Fix format of comments
Stanley Chu (2):
scsi: ufs: export ufshcd_link_recovery for vendor's error recovery
scsi: ufs-mediatek: add error recovery for suspend and resume
drivers/scsi/ufs/ufs-mediatek.c | 13 +++++++++++-- drivers/scsi/ufs/ufshcd.c | 3 ++- drivers/scsi/ufs/ufshcd.h | 1 + 3 files changed, 14 insertions(+), 3 deletions(-)
Signature · 1 line
2.18.0
PATCH v3 1/2 scsi: ufs: export ufshcd_link_recovery for vendor's error recovery
export ufshcd_link_recovery to allow vendors to recover failed link in vendor's callbacks.
--- drivers/scsi/ufs/ufshcd.c | 3 ++- drivers/scsi/ufs/ufshcd.h | 1 + 2 files changed, 3 insertions(+), 1 deletion(-)
drivers/scsi/ufs/ufshcd.c +2 -1
@@ -3756,7 +3756,7 @@ static int ufshcd_uic_change_pwr_mode(struct ufs_hba *hba, u8 mode)return ret; } -static int ufshcd_link_recovery (struct ufs_hba *hba) +int ufshcd_link_recovery (struct ufs_hba *hba) {int ret;unsigned long flags;
@@ -3783,6 +3783,7 @@ static int ufshcd_link_recovery(struct ufs_hba *hba)return ret; } +EXPORT_SYMBOL_GPL (ufshcd_link_recovery);static int __ufshcd_uic_hibern8_enter (struct ufs_hba *hba) {
drivers/scsi/ufs/ufshcd.h +1 -0
@@ -795,6 +795,7 @@ int ufshcd_alloc_host(struct device *, struct ufs_hba **);void ufshcd_dealloc_host (struct ufs_hba *);int ufshcd_hba_enable (struct ufs_hba *hba);int ufshcd_init (struct ufs_hba * ,void __iomem * ,unsigned int ); +int ufshcd_link_recovery (struct ufs_hba *hba);int ufshcd_make_hba_operational (struct ufs_hba *hba);void ufshcd_remove (struct ufs_hba *);int ufshcd_uic_hibern8_exit (struct ufs_hba *hba);
Signature · 1 line
2.18.0
PATCH v3 2/2 scsi: ufs-mediatek: add error recovery for suspend and resume
In reply to Stanley ChuOnce fail happens during suspend and resume flow if the desired low power link state is H8, link recovery is required for MediaTek UFS controller.
For resume flow, since power and clocks are already enabled before invoking vendor's resume callback, simply using ufshcd_link_recovery() inside callback is fine.
For suspend flow, the device power enters low power mode or is disabled before suspend callback, thus ufshcd_link_recovery() can not be directly used in vendor callback. One solution is to set the link to off state and then ufshcd_host_reset_and_restore() will be executed by ufshcd_suspend().
--- drivers/scsi/ufs/ufs-mediatek.c | 13 +++++++++++-- 1 file changed, 11 insertions(+), 2 deletions(-)
drivers/scsi/ufs/ufs-mediatek.c +11 -2
@@ -499,8 +499,15 @@ static int ufs_mtk_suspend(struct ufs_hba *hba, enum ufs_pm_op pm_op)if (ufshcd_is_link_hibern8 (hba)) { err =ufs_mtk_link_set_lpm (hba); -if (err) +if (err) { +/* +* Set link as off state enforcedly to trigger +* ufshcd_host_reset_and_restore() in ufshcd_suspend() +* for completed host reset. +*/ +ufshcd_set_link_off (hba);return -EAGAIN ; + } }if (!ufshcd_is_link_active (hba))
@@ -519,8 +526,10 @@ static int ufs_mtk_resume(struct ufs_hba *hba, enum ufs_pm_op pm_op)if (ufshcd_is_link_hibern8 (hba)) { err =ufs_mtk_link_set_hpm (hba); -if (err) +if (err) { + err =ufshcd_link_recovery (hba);return err; + } }return 0 ;
Signature · 1 line
2.18.0
Martin K. Petersen
AppliedStanley,
Quoted 2 lines
This patchset adds error recovery flow for suspend and resume in ufs-mediatek driver.
Applied to 5.7/scsi-queue. Thanks!
Signature · 6 lines
Martin K. Petersen Oracle Linux Engineering _______________________________________________ linux-arm-kernel mailing list [email protected] http://lists.infradead.org/mailman/listinfo/linux-arm-kernel