phy: tegra: Select USB_COMMON for usb_get_maximum_speed()
Subsystems (3)
PATCH 1/1 phy: tegra: Select USB_COMMON for usb_get_maximum_speed()
From: Thierry Reding <[email protected]>
The usb_get_maximum_speed() function is part of the usb-common module, so enable it by selecting the corresponding Kconfig symbol.
While at it, also make sure to depend on USB_SUPPORT because USB_PHY requires that. This can lead to Kconfig conflicts if USB_SUPPORT is not enabled while attempting to enable PHY_TEGRA_XUSB.
Reported-by kbuild test robot <[email protected]>
Suggested-by Nathan Chancellor <[email protected]>
Signed-off-by Thierry Reding <[email protected]>
---
Hi Greg,
sending this directly to you since it fixes a build issue introduced in the pull request that you merged last week, so it needs to be applied on top of that.
Thierry
drivers/phy/tegra/Kconfig | 3 ++- 1 file changed, 2 insertions(+), 1 deletion(-)
drivers/phy/tegra/Kconfig +2 -1
@@ -1,7 +1,8 @@ # SPDX-License-Identifier: GPL-2.0-only config PHY_TEGRA_XUSB tristate "NVIDIA Tegra XUSB pad controller driver" - depends on ARCH_TEGRA + depends on ARCH_TEGRA && USB_SUPPORT + select USB_COMMON select USB_CONN_GPIO select USB_PHY help
Signature · 1 line
2.24.1