selftests/ipc: Fix test failure seen after initial test run
PATCH 1/1 selftests/ipc: Fix test failure seen after initial test run
After successfully running the IPC msgque test once, subsequent runs result in a test failure:
$ sudo ./run_kselftest.sh TAP version 13 1..1 # selftests: ipc: msgque # Failed to get stats for IPC queue with id 0 # Failed to dump queue: -22 # Bail out! # # Pass 0 Fail 0 Xfail 0 Xpass 0 Skip 0 Error 0 not ok 1 selftests: ipc: msgque # exit=1
The dump_queue() function loops through the possible message queue index values using calls to msgctl(kern_id, MSG_STAT, ...) where kern_id represents the index value. The first time the test is ran, the initial index value of 0 is valid and the test is able to complete. The index value of 0 is not valid in subsequent test runs and the loop attempts to try index values of 1, 2, 3, and so on until a valid index value is found that corresponds to the message queue created earlier in the test.
The msgctl() syscall returns -1 and sets errno to EINVAL when invalid index values are used. The test failure is caused by incorrectly comparing errno to -EINVAL when cycling through possible index values.
Fix invalid test failures on subsequent runs of the msgque test by correctly comparing errno values to a non-negated EINVAL.
--- tools/testing/selftests/ipc/msgque.c | 2 +- 1 file changed, 1 insertion(+), 1 deletion(-)
tools/testing/selftests/ipc/msgque.c +1 -1
@@ -137,7 +137,7 @@ int dump_queue(struct msgque_data *msgque)for (kern_id =0 ; kern_id <256 ; kern_id++) { ret =msgctl (kern_id,MSG_STAT , &ds);if (ret <0 ) { -if (errno == -EINVAL ) +if (errno ==EINVAL )continue ;printf ("Failed to get stats for IPC queue with id %d\n" , kern_id);
Signature · 1 line
2.17.1