dt-bindings: usb: dwc2: add power-domains property
Subsystems (3)
PATCH 1/1 dt-bindings: usb: dwc2: add power-domains property
A test with the command below gives this error:
arch/arm64/boot/dts/rockchip/px30-evb.dt.yaml: usb@ff300000:
'power-domains' does not match any of the regexes: 'pinctrl-[0-9]+'
With the conversion to yaml it also filters things in a node that are used by other drivers like 'power-domains' for Rockchip px30 usb nodes, so add them to 'dwc2.yaml'.
make ARCH=arm64 dtbs_check DT_SCHEMA_FILES=Documentation/devicetree/bindings/usb/dwc2.yaml
--- Documentation/devicetree/bindings/usb/dwc2.yaml | 3 +++ 1 file changed, 3 insertions(+)
Documentation/devicetree/bindings/usb/dwc2.yaml +3 -0
@@ -78,6 +78,9 @@ properties: phy-names: const: usb2-phy + power-domains: + maxItems: 1 + vbus-supply: description: reference to the VBUS regulator. Depending on the current mode this is enabled (in "host" mode") or disabled (in "peripheral" mode). The
Signature · 1 line
2.11.0
Quoted 10 lines · Johan Jonker
A test with the command below gives this error:
arch/arm64/boot/dts/rockchip/px30-evb.dt.yaml: usb@ff300000:
'power-domains' does not match any of the regexes: 'pinctrl-[0-9]+'With the conversion to yaml it also filters things in a node that are used by other drivers like 'power-domains' for Rockchip px30 usb nodes, so add them to '
dwc2.yaml'.
Quoted 8 lines
make ARCH=arm64
dtbs_checkDT_SCHEMA_FILES=Documentation/devicetree/bindings/usb/dwc2.yamlSigned-off-by Johan Jonker <[email protected]>--- Documentation/devicetree/bindings/usb/dwc2.yaml | 3 +++ 1 file changed, 3 insertions(+)
Applied, thanks!