Skip to contentSkip to conversation

usb: xhci: Fix NULL pointer dereference as part of completion

PATCH In review Sriharsha Allenki 2 participants 2 messages May 5, 2020

Subsystems (3)
lore
Share & tools
lore
#0 lore raw

PATCH 1/1 usb: xhci: Fix NULL pointer dereference as part of completion

On platforms with IOMMU enabled, multiple SGs can be coalesced into one by the IOMMU driver. In that case the SG list processing as part of the completion of a urb on a bulk endpoint can result into a NULL pointer dereference with the below stack dump.

<6> Unable to handle kernel NULL pointer dereference at virtual address 0000000c <6> pgd = c0004000
<6> [0000000c] *pgd=00000000
<6> Internal error: Oops: 5 [#1] PREEMPT SMP ARM
<2> PC is at xhci_queue_bulk_tx+0x454/0x80c
<2> LR is at xhci_queue_bulk_tx+0x44c/0x80c
<2> pc : [<c08907c4>] lr : [<c08907bc>] psr: 000000d3

<2> sp : ca337c80  ip : 00000000  fp : ffffffff
<2> r10: 00000000  r9 : 50037000  r8 : 00004000
<2> r7 : 00000000  r6 : 00004000  r5 : 00000000  r4 : 00000000
<2> r3 : 00000000  r2 : 00000082  r1 : c2c1a200  r0 : 00000000

<2> Flags: nzcv IRQs off FIQs off Mode SVC_32 ISA ARM Segment none <2> Control: 10c0383d Table: b412c06a DAC: 00000051
<6> Process usb-storage (pid: 5961, stack limit = 0xca336210) <snip>
<2> [<c08907c4>] (xhci_queue_bulk_tx)
<2> [<c0881b3c>] (xhci_urb_enqueue)
<2> [<c0831068>] (usb_hcd_submit_urb)
<2> [<c08350b4>] (usb_sg_wait)
<2> [<c089f384>] (usb_stor_bulk_transfer_sglist)
<2> [<c089f2c0>] (usb_stor_bulk_srb)
<2> [<c089fe38>] (usb_stor_Bulk_transport)
<2> [<c089f468>] (usb_stor_invoke_transport)
<2> [<c08a11b4>] (usb_stor_control_thread)
<2> [<c014a534>] (kthread)

The above NULL pointer dereference is the result of block_len and the sent_len set to zero after the first SG of the list when IOMMU driver is enabled. Because of this the loop of processing the SGs has run more than num_sgs which resulted in a sg_next on the last SG of the list which has SG_END set.

Fix this by check for the sg before any attributes of the sg are accessed.

Fixes f9c589e142d04 ("xhci: TD-fragment, align the unsplittable case with a bounce buffer")
---
 drivers/usb/host/xhci-ring.c | 4 ++--
 1 file changed, 2 insertions(+), 2 deletions(-)
drivers/usb/host/xhci-ring.c +2 -2
index a78787bb5133..18141b38f7bf 100644
@@ -3399,8 +3399,8 @@ int xhci_queue_bulk_tx(struct xhci_hcd *xhci, gfp_t mem_flags,
 			/* New sg entry */
 			--num_sgs;
 			sent_len -= block_len;
-			if (num_sgs != 0) {
-				sg = sg_next(sg);
+			sg = sg_next(sg);
+			if (num_sgs != 0 && sg) {
 				block_len = sg_dma_len(sg);
 				addr = (u64) sg_dma_address(sg);
 				addr += sent_len;
Signature · 1 line
The Qualcomm Innovation Center, Inc. is a member of the Code Aurora Forum, a Linux Foundation Collaborative Project
#1 lore raw
Quoted 54 lines · Sriharsha Allenki

On platforms with IOMMU enabled, multiple SGs can be coalesced into one by the IOMMU driver. In that case the SG list processing as part of the completion of a urb on a bulk endpoint can result into a NULL pointer dereference with the below stack dump.

<6> Unable to handle kernel NULL pointer dereference at virtual address 0000000c <6> pgd = c0004000
<6> [0000000c] *pgd=00000000
<6> Internal error: Oops: 5 [#1] PREEMPT SMP ARM
<2> PC is at xhci_queue_bulk_tx+0x454/0x80c
<2> LR is at xhci_queue_bulk_tx+0x44c/0x80c
<2> pc : [<c08907c4>] lr : [<c08907bc>] psr: 000000d3

<2> sp : ca337c80  ip : 00000000  fp : ffffffff
<2> r10: 00000000  r9 : 50037000  r8 : 00004000
<2> r7 : 00000000  r6 : 00004000  r5 : 00000000  r4 : 00000000
<2> r3 : 00000000  r2 : 00000082  r1 : c2c1a200  r0 : 00000000

<2> Flags: nzcv IRQs off FIQs off Mode SVC_32 ISA ARM Segment none <2> Control: 10c0383d Table: b412c06a DAC: 00000051
<6> Process usb-storage (pid: 5961, stack limit = 0xca336210) <snip>
<2> [<c08907c4>] (xhci_queue_bulk_tx)
<2> [<c0881b3c>] (xhci_urb_enqueue)
<2> [<c0831068>] (usb_hcd_submit_urb)
<2> [<c08350b4>] (usb_sg_wait)
<2> [<c089f384>] (usb_stor_bulk_transfer_sglist)
<2> [<c089f2c0>] (usb_stor_bulk_srb)
<2> [<c089fe38>] (usb_stor_Bulk_transport)
<2> [<c089f468>] (usb_stor_invoke_transport)
<2> [<c08a11b4>] (usb_stor_control_thread)
<2> [<c014a534>] (kthread)

The above NULL pointer dereference is the result of block_len and the sent_len set to zero after the first SG of the list when IOMMU driver is enabled. Because of this the loop of processing the SGs has run more than num_sgs which resulted in a sg_next on the last SG of the list which has SG_END set.

Fix this by check for the sg before any attributes of the sg are accessed.

Fixes f9c589e142d04 ("xhci: TD-fragment, align the unsplittable case with a bounce buffer")
---
 drivers/usb/host/xhci-ring.c | 4 ++--
 1 file changed, 2 insertions(+), 2 deletions(-)
drivers/usb/host/xhci-ring.c +0 -0
index a78787bb5133..18141b38f7bf 100644

drivers/usb/host/xhci-ring.c int xhci_queue_bulk_tx(struct xhci_hcd *xhci, gfp_t mem_flags, · line 3406

Quoted 10 lines
drivers/usb/host/xhci-ring.c +2 -2
@@ -3399,8 +3399,8 @@ int xhci_queue_bulk_tx(struct xhci_hcd *xhci, gfp_t mem_flags,
 			/* New sg entry */
 			--num_sgs;
 			sent_len -= block_len;
-			if (num_sgs != 0) {
-				sg = sg_next(sg);
+			sg = sg_next(sg);
+			if (num_sgs != 0 && sg) {
 				block_len = sg_dma_len(sg);
 				addr = (u64) sg_dma_address(sg);
 				addr += sent_len;

Nice catch, thanks.

Adding to queue.

-Mathias