PCI: brcmstb: Some minor fixes/features
Subsystems (6)
v3 cover PCI: brcmstb: Some minor fixes/features
v3 -- A change was submitted to [1] to make 'aspm-no-l0s' a general
property for PCIe devices. As such, the STB PCIe YAML file merely notes that it may be used.
v2 -- Dropped commit concerning CRS.
-- Chanded new prop 'brcm,aspm-en-l0s' to 'aspm-no-l0s'. -- Capitalize first letter in commit subject line; spelling.
v1 -- original
[1] https://github.com/devicetree-org/dt-schema/blob/master/schemas/pci/pci-bus.yaml
Jim Quinlan (4):
PCI: brcmstb: Don't clk_put() a managed clock
PCI: brcmstb: Fix window register offset from 4 to 8
dt-bindings: PCI: brcmstb: New prop 'aspm-no-l0s'
PCI: brcmstb: Disable L0s component of ASPM if requested
.../bindings/pci/brcm,stb-pcie.yaml | 2 ++ drivers/pci/controller/pcie-brcmstb.c | 19 +++++++++++++++---- 2 files changed, 17 insertions(+), 4 deletions(-)
Signature · 1 line
2.17.1
PATCH v3 1/4 PCI: brcmstb: Don't clk_put() a managed clock
From: Jim Quinlan <[email protected]>
clk_put() was being invoked on a clock obtained by devm_clk_get_optional().
--- drivers/pci/controller/pcie-brcmstb.c | 1 - 1 file changed, 1 deletion(-)
drivers/pci/controller/pcie-brcmstb.c +0 -1
@@ -899,7 +899,6 @@ static void __brcm_pcie_remove(struct brcm_pcie *pcie)brcm_msi_remove (pcie);brcm_pcie_turn_off (pcie);clk_disable_unprepare (pcie->clk); -clk_put (pcie->clk); }static int brcm_pcie_remove (struct platform_device *pdev)
Signature · 1 line
2.17.1
Re: [PATCH v3 1/4] PCI: brcmstb: Don't clk_put() a managed clock
Quoted 8 lines · Jim Quinlan
From: Jim Quinlan <[email protected]>
clk_put()was being invoked on a clock obtained bydevm_clk_get_optional().Signed-off-by Jim Quinlan <[email protected]>Acked-by Florian Fainelli <[email protected]>
This one should also have:
controller driver")
not sure if Bjorn can add it while applying.
Signature · 1 line
Florian
PATCH v3 2/4 PCI: brcmstb: Fix window register offset from 4 to 8
In reply to Jim QuinlanFrom: Jim Quinlan <[email protected]>
The outbound memory window registers were being referenced with an incorrect stride offset. This probably wasn't noticed previously as there was likely only one such window employed.
--- drivers/pci/controller/pcie-brcmstb.c | 4 ++-- 1 file changed, 2 insertions(+), 2 deletions(-)
drivers/pci/controller/pcie-brcmstb.c +2 -2
@@ -54,11 +54,11 @@#define PCIE_MISC_CPU_2_PCIE_MEM_WIN0_LO 0x400c#define PCIE_MEM_WIN0_LO (win) \ - PCIE_MISC_CPU_2_PCIE_MEM_WIN0_LO + ((win) * 4) + PCIE_MISC_CPU_2_PCIE_MEM_WIN0_LO + ((win) * 8)#define PCIE_MISC_CPU_2_PCIE_MEM_WIN0_HI 0x4010#define PCIE_MEM_WIN0_HI (win) \ - PCIE_MISC_CPU_2_PCIE_MEM_WIN0_HI + ((win) * 4) + PCIE_MISC_CPU_2_PCIE_MEM_WIN0_HI + ((win) * 8)#define PCIE_MISC_RC_BAR1_CONFIG_LO 0x402c#define PCIE_MISC_RC_BAR1_CONFIG_LO_SIZE_MASK 0x1f
Signature · 1 line
2.17.1
PATCH v3 3/4 dt-bindings: PCI: brcmstb: New prop 'aspm-no-l0s'
In reply to Jim QuinlanFrom: Jim Quinlan <[email protected]>
For various reasons, one may want to disable the ASPM L0s capability.
--- Documentation/devicetree/bindings/pci/brcm,stb-pcie.yaml | 2 ++ 1 file changed, 2 insertions(+)
Documentation/devicetree/bindings/pci/brcm,stb-pcie.yaml +2 -0
@@ -56,6 +56,8 @@ properties: description: Indicates usage of spread-spectrum clocking. type: boolean + aspm-no-l0s: true + required: - reg - dma-ranges
Signature · 1 line
2.17.1
Re: [PATCH v3 3/4] dt-bindings: PCI: brcmstb: New prop 'aspm-no-l0s'
Quoted 10 lines · Jim Quinlan
From: Jim Quinlan <[email protected]>
For various reasons, one may want to disable the ASPM L0s capability.
Signed-off-by Jim Quinlan <[email protected]>--- Documentation/devicetree/bindings/pci/brcm,stb-pcie.yaml | 2 ++ 1 file changed, 2 insertions(+)
PATCH v3 4/4 PCI: brcmstb: Disable L0s component of ASPM if requested
In reply to Jim QuinlanFrom: Jim Quinlan <[email protected]>
Some informal internal experiments has shown that the BrcmSTB ASPM L0s savings may introduce an undesirable noise signal on some customers' boards. In addition, L0s was found lacking in realized power savings, especially relative to the L1 ASPM component. This is BrcmSTB's experience and may not hold for others. At any rate, if the 'aspm-no-l0s' property is present L0s will be disabled.
--- drivers/pci/controller/pcie-brcmstb.c | 14 +++++++++++++- 1 file changed, 13 insertions(+), 1 deletion(-)
drivers/pci/controller/pcie-brcmstb.c +13 -1
@@ -41,6 +41,9 @@#define PCIE_RC_CFG_PRIV1_ID_VAL3 0x043c#define PCIE_RC_CFG_PRIV1_ID_VAL3_CLASS_CODE_MASK 0xffffff +#define PCIE_RC_CFG_PRIV1_LINK_CAPABILITY 0x04dc +#define PCIE_RC_CFG_PRIV1_LINK_CAPABILITY_ASPM_SUPPORT_MASK 0xc00 +#define PCIE_RC_DL_MDIO_ADDR 0x1100#define PCIE_RC_DL_MDIO_WR_DATA 0x1104#define PCIE_RC_DL_MDIO_RD_DATA 0x1108
@@ -693,7 +696,7 @@ static int brcm_pcie_setup(struct brcm_pcie *pcie)int num_out_wins =0 ;u16 nlw, cls, lnksta;int i, ret; -u32 tmp; +u32 tmp, aspm_support;/* Reset the bridge */ brcm_pcie_bridge_sw_init_set (pcie,1 );
@@ -803,6 +806,15 @@ static int brcm_pcie_setup(struct brcm_pcie *pcie) num_out_wins++; } +/* Don't advertise L0s capability if 'aspm-no-l0s' */ + aspm_support =PCIE_LINK_STATE_L1 ; +if (!of_property_read_bool (pcie->np,"aspm-no-l0s" )) + aspm_support |=PCIE_LINK_STATE_L0S ; + tmp =readl (base +PCIE_RC_CFG_PRIV1_LINK_CAPABILITY ); +u32p_replace_bits (&tmp, aspm_support, +PCIE_RC_CFG_PRIV1_LINK_CAPABILITY_ASPM_SUPPORT_MASK ); +writel (tmp, base +PCIE_RC_CFG_PRIV1_LINK_CAPABILITY ); +/* * For config space accesses on the RC, show the right class for * a PCIe-PCIe bridge (the default setting is to be EP mode).
Signature · 1 line
2.17.1
Lorenzo Pieralisi
AppliedQuoted 18 lines · Jim Quinlan
v3 -- A change was submitted to [1] to make 'aspm-no-l0s' a general
property for PCIe devices. As such, the STB PCIe YAML file merely notes that it may be used.v2 -- Dropped commit concerning CRS.
-- Chanded new prop 'brcm,aspm-en-l0s' to 'aspm-no-l0s'. -- Capitalize first letter in commit subject line; spelling.v1 -- original
[1] https://github.com/devicetree-org/dt-schema/blob/master/schemas/pci/pci-bus.yaml
Jim Quinlan (4):
PCI: brcmstb: Don'tclk_put()a managed clock
PCI: brcmstb: Fix window register offset from 4 to 8
dt-bindings: PCI: brcmstb: New prop 'aspm-no-l0s'
PCI: brcmstb: Disable L0s component of ASPM if requested
Quoted 3 lines
.../bindings/pci/brcm,stb-pcie.yaml | 2 ++ drivers/pci/controller/pcie-brcmstb.c | 19 +++++++++++++++---- 2 files changed, 17 insertions(+), 4 deletions(-)
Applied to pci/brcmstb, thanks !
Lorenzo