Skip to contentSkip to conversation

imx: Add support for i.MX8MM Beacon EmbeddedWorks devkit.

PATCH New Adam Ford 2 participants 2 messages May 3, 2020 – May 11, 2020

Subsystems (3)
lore
Share & tools
lore

Adam Ford

author
#0 lore raw

PATCH v2 1/1 imx: Add support for i.MX8MM Beacon EmbeddedWorks devkit.

Beacon EmbeddedWorks, formerly known as Logic PD, is releasing a devkit based on the i.MX8M Mini SoC consisting of baseboard + SOM.

It supports eMMC on the SOM, microSD on the baseboard, various GPIO, the PINCTRL, and UART.

---
V2: Remove do_reset from SPL and enable caches during SPL.
Remove more remnants of un-related hardware. Add MAINTAINERS file.

arch/arm/dts/Makefile +2 -1
index 2c123bd6da..9c0fb8488d 100644
@@ -733,7 +733,8 @@ dtb-$(CONFIG_ARCH_IMX8M) += \
 	imx8mm-verdin.dtb \
 	imx8mn-ddr4-evk.dtb \
 	imx8mq-evk.dtb \
-	imx8mp-evk.dtb
+	imx8mp-evk.dtb \
+	imx8mm-beacon-kit.dtb
 
 dtb-$(CONFIG_ARCH_IMXRT) += imxrt1050-evk.dtb \
 	imxrt1020-evk.dtb
arch/arm/dts/imx8mm-beacon-baseboard.dtsi new file +285 -0

285 lines not on this page · raw message

arch/arm/dts/imx8mm-beacon-kit-u-boot.dtsi new file +131 -0

131 lines not on this page · raw message

arch/arm/dts/imx8mm-beacon-kit.dts new file +19 -0
new file mode 100644
index 0000000000..74a7b0cc10
@@ -0,0 +1,19 @@
+// SPDX-License-Identifier: (GPL-2.0 OR MIT)
+/*
+ * Copyright 2020 Compass Electronics Group, LLC
+ */
+
+/dts-v1/;
+
+#include "imx8mm.dtsi"
+#include "imx8mm-beacon-som.dtsi"
+#include "imx8mm-beacon-baseboard.dtsi"
+
+/ {
+	model = "Beacon EmbeddedWorks i.MX8M Mini Development Kit";
+	compatible = "beacon,imx8mm-beacon-kit", "fsl,imx8mm";
+
+	chosen {
+		stdout-path = &uart2;
+	};
+};
arch/arm/dts/imx8mm-beacon-som.dtsi new file +390 -0

390 lines not on this page · raw message

arch/arm/mach-imx/imx8m/Kconfig +7 -0
index 58f1758ab6..6f6e63472f 100644
@@ -56,6 +56,12 @@ config TARGET_VERDIN_IMX8MM
        select SUPPORT_SPL
        select IMX8M_LPDDR4
 
+config TARGET_IMX8MM_BEACON
+	bool "imx8mm Beacon Embedded devkit"
+	select IMX8MM
+	select SUPPORT_SPL
+	select IMX8M_LPDDR4
+
 endchoice
 
 source "board/freescale/imx8mq_evk/Kconfig"
@@ -63,5 +69,6 @@ source "board/freescale/imx8mm_evk/Kconfig"
 source "board/freescale/imx8mn_evk/Kconfig"
 source "board/freescale/imx8mp_evk/Kconfig"
 source "board/toradex/verdin-imx8mm/Kconfig"
+source "board/beacon/imx8mm/Kconfig"
 
 endif
board/beacon/imx8mm/Kconfig new file +14 -0
new file mode 100644
index 0000000000..df3125eae9
@@ -0,0 +1,14 @@
+if TARGET_IMX8MM_BEACON
+
+config SYS_BOARD
+	default "imx8mm"
+
+config SYS_VENDOR
+	default "beacon"
+
+config SYS_CONFIG_NAME
+	default "imx8mm_beacon"
+
+source "board/freescale/common/Kconfig"
+
+endif
board/beacon/imx8mm/MAINTAINERS new file +7 -0
new file mode 100644
index 0000000000..e887db20a2
@@ -0,0 +1,7 @@
+i.MX8MM Beacon EmbeddedWorks Devkit
+
+M:	Adam Ford <[email protected]>
+S:	Maintained
+F:	board/beacon/imx8mm/
+F:	include/configs/imx8mm_beacon.h
+F:	configs/imx8mm_beacon_defconfig
board/beacon/imx8mm/Makefile new file +13 -0
new file mode 100644
index 0000000000..7d3bd3112c
@@ -0,0 +1,13 @@
+#
+# Copyright 2020 Compass Electronics Group, LLC
+#
+# SPDX-License-Identifier:      GPL-2.0+
+#
+
+obj-y += imx8mm_beacon.o
+obj-y += ../../freescale/common/
+
+ifdef CONFIG_SPL_BUILD
+obj-y += spl.o
+obj-y += lpddr4_timing.o
+endif
board/beacon/imx8mm/README new file +37 -0
new file mode 100644
index 0000000000..4223fbd15d
@@ -0,0 +1,37 @@
+U-Boot for the Beacon EmbeddedWorks Devkit
+
+Quick Start
+===========
+- Build the ARM Trusted firmware binary
+- Get ddr firmware
+- Build U-Boot
+- Boot
+
+Get and Build the ARM Trusted firmware
+======================================
+Note: $(srctree) is U-Boot source directory
+
+$ git clone https://source.codeaurora.org/external/imx/imx-atf
+$ git checkout imx_4.19.35_1.0.0
+$ make PLAT=imx8mm bl31 ARCH=arm CROSS_COMPILE=aarch64-linux-gnu-
+$ cp build/imx8mm/release/bl31.bin $(srctree)
+
+Get the DDR firmware
+====================
+$ wget https://www.nxp.com/lgfiles/NMG/MAD/YOCTO/firmware-imx-8.5.bin
+$ chmod +x firmware-imx-8.5.bin
+$ ./firmware-imx-8.5
+$ cp firmware-imx-8.5/firmware/ddr/synopsys/lpddr4*.bin $(srctree)
+
+Build U-Boot
+============
+$ make imx8mm_beacon_defconfig
+$ make flash.bin ARCH=arm CROSS_COMPILE=aarch64-linux-gnu- ATF_LOAD_ADDR=0x920000
+
+Burn U-Boot to microSD Card
+===========================
+$ sudo dd if=flash.bin of=/dev/sd[x] bs=1024 seek=33
+
+Boot
+====
+Set Boot switch to SD boot
board/beacon/imx8mm/imx8mm_beacon.c new file +67 -0

67 lines not on this page · raw message

board/beacon/imx8mm/lpddr4_timing.c new file +1980 -0

1,980 lines not on this page · raw message

board/beacon/imx8mm/spl.c new file +155 -0

30 lines not on this page · raw message

configs/imx8mm_beacon_defconfig new file +104 -0

104 lines not on this page · raw message

include/configs/imx8mm_beacon.h new file +152 -0

152 lines not on this page · raw message

The rest of this diff is not shown. View the raw message.

Signature · 1 line
2.25.1

Part of the diff is not shown here. View the raw message.

#1 lore raw

PATCH v2 1/1 imx: Add support for i.MX8MM Beacon EmbeddedWorks devkit.

Quoted 6 lines

Beacon EmbeddedWorks, formerly known as Logic PD, is releasing a devkit based on the i.MX8M Mini SoC consisting of baseboard + SOM.
It supports eMMC on the SOM, microSD on the baseboard, various GPIO, the PINCTRL, and UART.

Applied to u-boot-imx, master, thanks !

Best regards,
Stefano Babic

Signature · 5 lines
=====================================================================
DENX Software Engineering GmbH,      Managing Director: Wolfgang Denk
HRB 165235 Munich, Office: Kirchenstr.5, D-82194 Groebenzell, Germany
Phone: +49-8142-66989-53 Fax: +49-8142-66989-80 Email: sbabic at denx.de
=====================================================================