net: broadcom: Select BROADCOM_PHY for BCMGENET
Subsystems (2)
PATCH v2 1/1 net: broadcom: Select BROADCOM_PHY for BCMGENET
The GENET controller on the Raspberry Pi 4 (2711) is typically interfaced with an external Broadcom PHY via a RGMII electrical interface. To make sure that delays are properly configured at the PHY side, ensure that we the dedicated Broadcom PHY driver (CONFIG_BROADCOM_PHY) is enabled for this to happen.
---
Changes in v2:
- use select instead of imply
drivers/net/ethernet/broadcom/Kconfig | 1 + 1 file changed, 1 insertion(+)
drivers/net/ethernet/broadcom/Kconfig +1 -0
@@ -69,6 +69,7 @@ config BCMGENET select BCM7XXX_PHY select MDIO_BCM_UNIMAC select DIMLIB + select BROADCOM_PHY if ARCH_BCM2835 help This driver supports the built-in Ethernet MACs found in the Broadcom BCM7xxx Set Top Box family chipset.
Signature · 1 line
2.17.1
David Miller
maintainerFrom: Florian Fainelli <[email protected]>
Date: Wed, 13 May 2020 08:51:51 -0700
Quoted 9 lines
The GENET controller on the Raspberry Pi 4 (2711) is typically interfaced with an external Broadcom PHY via a RGMII electrical interface. To make sure that delays are properly configured at the PHY side, ensure that we the dedicated Broadcom PHY driver (
CONFIG_BROADCOM_PHY) is enabled for this to happen.Fixes 402482a6a78e ("net: bcmgenet: Clear ID_MODE_DIS in EXT_RGMII_OOB_CTRL when not needed")Reported-by Marek Szyprowski <[email protected]>Signed-off-by Florian Fainelli <[email protected]>
Applied and queued up for -stable, thanks Florian.