Skip to contentSkip to conversation

zswap: docs/vm: Fix typo accept_threshold_percent in zswap.rst

PATCH New Sedat Dilek 1 participant 1 message Jun 1, 2020 Documentation

lore
Share & tools
lore
#0 lore raw

PATCH 1/1 zswap: docs/vm: Fix typo accept_threshold_percent in zswap.rst

Recently, I switched over from swap-file to zramswap.

When reading the Documentation/vm/zswap.rst file I fell over this typo.

The parameter is called accept_threshold_percent not accept_threhsold_percent in /sys/module/zswap/parameters/ directory.

Fixes 45190f01dd402 ("mm/zswap.c: add allocation hysteresis if pool limit is hit")
Cc Vitaly Wool <[email protected]>
---
 Documentation/vm/zswap.rst | 4 ++--
 1 file changed, 2 insertions(+), 2 deletions(-)
Documentation/vm/zswap.rst +2 -2
index f8c6a79d7c70..d8d9fa4a1f0d 100644
@@ -140,10 +140,10 @@ without any real benefit but with a performance drop for the system), a
 special parameter has been introduced to implement a sort of hysteresis to
 refuse taking pages into zswap pool until it has sufficient space if the limit
 has been hit. To set the threshold at which zswap would start accepting pages
-again after it became full, use the sysfs ``accept_threhsold_percent``
+again after it became full, use the sysfs ``accept_threshold_percent``
 attribute, e. g.::
 
-	echo 80 > /sys/module/zswap/parameters/accept_threhsold_percent
+	echo 80 > /sys/module/zswap/parameters/accept_threshold_percent
 
 Setting this parameter to 100 will disable the hysteresis.
 
Signature · 1 line
2.27.0.rc2