ARM: dts: imx6qdl-gw53xx: allow boot firmware to set eth1 MAC
Subsystems (2)
PATCH 1/1 ARM: dts: imx6qdl-gw53xx: allow boot firmware to set eth1 MAC
The GW53xx has a PCIe based GbE as the 2nd ethernet device. The boot firmware will populate the local-mac-address field of the device aliased to ethernet1 thus adding the PCIe device to dt allows boot firmware to set its MAC address.
Signed-off-by Tim Harvey <[email protected]>
--- arch/arm/boot/dts/imx6qdl-gw53xx.dtsi | 18 ++++++++++++++++++ 1 file changed, 18 insertions(+)
arch/arm/boot/dts/imx6qdl-gw53xx.dtsi +18 -0
@@ -8,6 +8,7 @@ / { /* these are used by bootloader for disabling nodes */ aliases { + ethernet1 = ð1; led0 = &led0; led1 = &led1; led2 = &led2;
@@ -341,6 +342,23 @@ pinctrl-0 = <&pinctrl_pcie>; reset-gpio = <&gpio1 29 GPIO_ACTIVE_LOW>; status = "okay"; + + pcie@0,0,0 { + reg = <0x0000 0 0 0 0>; + + pcie@1,0,0 { + reg = <0x0000 0 0 0 0>; + + pcie@2,4,0 { + reg = <0x2000 0 0 0 0>; + + eth1: pcie@4,0,0 { + reg = <0x0000 0 0 0 0>; + local-mac-address = [00 00 00 00 00 00]; + }; + }; + }; + }; }; &pwm2 {
Signature · 7 lines
2.7.4 _______________________________________________ linux-arm-kernel mailing list [email protected] http://lists.infradead.org/mailman/listinfo/linux-arm-kernel
Shawn Guo
AppliedQuoted 6 lines · Tim Harvey
The GW53xx has a PCIe based GbE as the 2nd ethernet device. The boot firmware will populate the local-mac-address field of the device aliased to ethernet1 thus adding the PCIe device to dt allows boot firmware to set its MAC address.
Signed-off-by Tim Harvey <[email protected]>
Applied, thanks.