pinctrl: qcom: ipq8074: route gpio interrupts to APPS
Subsystems (5)
PATCH v2 1/1 pinctrl: qcom: ipq8074: route gpio interrupts to APPS
set target proc as APPS to route the gpio interrupts to APPS
Co-developed-by Rajkumar Ayyasamy <[email protected]>
Signed-off-by Rajkumar Ayyasamy <[email protected]>
Signed-off-by Kathiravan T <[email protected]>
--- drivers/pinctrl/qcom/pinctrl-ipq8074.c | 1 + 1 file changed, 1 insertion(+)
drivers/pinctrl/qcom/pinctrl-ipq8074.c +1 -0
@@ -50,6 +50,7 @@ .intr_enable_bit = 0, \ .intr_status_bit = 0, \ .intr_target_bit = 5, \ + .intr_target_kpss_val = 3, \ .intr_raw_status_bit = 4, \ .intr_polarity_bit = 1, \ .intr_detection_bit = 2, \
Signature · 1 line
QUALCOMM INDIA, on behalf of Qualcomm Innovation Center, Inc. is a member of Code Aurora Forum, hosted by The Linux Foundation
Quoted 5 lines · Kathiravan T
set target proc as APPS to route the gpio interrupts to APPS
Co-developed-by Rajkumar Ayyasamy <[email protected]>Signed-off-by Rajkumar Ayyasamy <[email protected]>Signed-off-by Kathiravan T <[email protected]>
Thanks for the quick respin.
Acked-by Bjorn Andersson <[email protected]>
Regards,
Bjorn
Quoted 19 lines
--- drivers/pinctrl/qcom/pinctrl-ipq8074.c | 1 + 1 file changed, 1 insertion(+)drivers/pinctrl/qcom/pinctrl-ipq8074.c +1
-0@@ -50,6 +50,7 @@ .intr_enable_bit = 0, \ .intr_status_bit = 0, \ .intr_target_bit = 5, \ + .intr_target_kpss_val = 3, \ .intr_raw_status_bit = 4, \ .intr_polarity_bit = 1, \ .intr_detection_bit = 2, \Signature · 1 line
QUALCOMM INDIA, on behalf of Qualcomm Innovation Center, Inc. is a member of Code Aurora Forum, hosted by The Linux Foundation
Quoted 5 lines · Kathiravan T
set target proc as APPS to route the gpio interrupts to APPS
Co-developed-by Rajkumar Ayyasamy <[email protected]>Signed-off-by Rajkumar Ayyasamy <[email protected]>Signed-off-by Kathiravan T <[email protected]>
Patch applied.
Yours,
Linus Walleij