spi: spi-qcom-qspi: Avoid some per-transfer overhead
Subsystems (2)
v2 cover spi: spi-qcom-qspi: Avoid some per-transfer overhead
Not to be confused with the similar series I posed for the _other_ Qualcomm SPI controller (spi-geni-qcom) [1], this one avoids the overhead on the Quad SPI controller.
It's based atop the current Qualcomm tree including Rajendra's ("spi:
spi-qcom-qspi: Use OPP API to set clk/perf state"). As discussed in individual patches, these could ideally land through the Qualcomm tree with Mark's Ack.
Measuring:
* Before OPP / Interconnect patches reading all flash takes: ~3.4 seconds
* After OPP / Interconnect patches reading all flash takes: ~4.7 seconds
* After this patch reading all flash takes: ~3.3 seconds
[1] https://lore.kernel.org/r/[email protected]
[2] https://lore.kernel.org/r/[email protected]
Changes in v2:
- Return error from runtime resume if dev_pm_opp_set_rate() fails.
Douglas Anderson (2):
spi: spi-qcom-qspi: Avoid clock setting if not needed
spi: spi-qcom-qspi: Set an autosuspend delay of 250 ms
drivers/spi/spi-qcom-qspi.c | 43 ++++++++++++++++++++++++++++--------- 1 file changed, 33 insertions(+), 10 deletions(-)
Signature · 1 line
2.27.0.383.g050319c2ae-goog
PATCH v2 1/2 spi: spi-qcom-qspi: Avoid clock setting if not needed
As per recent changes to the spi-qcom-qspi, now when we set the clock we'll call into the interconnect framework and also call the OPP API. Those are expensive operations. Let's avoid calling them if possible. This has a big impact on getting transfer rates back up to where they were (or maybe slightly better) before those patches landed.
---
This applies atop the Qualcomm tree after Rajendra's ("spi:
spi-qcom-qspi: Use OPP API to set clk/perf state") patch and I'd hope it could land there with Mark's Ack just like the patch it Fixes did.
Changes in v2:
- Return error from runtime resume if dev_pm_opp_set_rate() fails.
drivers/spi/spi-qcom-qspi.c | 41 ++++++++++++++++++++++++++++--------- 1 file changed, 31 insertions(+), 10 deletions(-)
drivers/spi/spi-qcom-qspi.c +31 -10
@@ -144,6 +144,7 @@ struct qcom_qspi {struct icc_path *icc_path_cpu_to_qspi;struct opp_table *opp_table;bool has_opp_table; +unsigned long last_speed;/* Lock to protect data accessed by IRQs */ spinlock_t lock; };
@@ -226,19 +227,13 @@ static void qcom_qspi_handle_err(struct spi_master *master,spin_unlock_irqrestore (&ctrl->lock, flags); } -static int qcom_qspi_transfer_one (struct spi_master *master, -struct spi_device *slv, -struct spi_transfer *xfer) +static int qcom_qspi_set_speed (struct qcom_qspi *ctrl,unsigned long speed_hz) { -struct qcom_qspi *ctrl =spi_master_get_devdata (master);int ret; -unsigned long speed_hz; -unsigned long flags;unsigned int avg_bw_cpu; - speed_hz = slv->max_speed_hz; -if (xfer->speed_hz) - speed_hz = xfer->speed_hz; +if (speed_hz == ctrl->last_speed) +return 0 ;/* In regular operation (SBL_EN=1) core must be 4x transfer clock */ ret =dev_pm_opp_set_rate (ctrl->dev, speed_hz *4 );
@@ -259,6 +254,28 @@ static int qcom_qspi_transfer_one(struct spi_master *master,return ret; } + ctrl->last_speed = speed_hz; + +return 0 ; +} + +static int qcom_qspi_transfer_one (struct spi_master *master, +struct spi_device *slv, +struct spi_transfer *xfer) +{ +struct qcom_qspi *ctrl =spi_master_get_devdata (master); +int ret; +unsigned long speed_hz; +unsigned long flags; + + speed_hz = slv->max_speed_hz; +if (xfer->speed_hz) + speed_hz = xfer->speed_hz; + + ret =qcom_qspi_set_speed (ctrl, speed_hz); +if (ret) +return ret; +spin_lock_irqsave (&ctrl->lock, flags);/* We are half duplex, so either rx or tx will be set */
@@ -602,7 +619,11 @@ static int __maybe_unused qcom_qspi_runtime_resume(struct device *dev)return ret; } -return clk_bulk_prepare_enable (QSPI_NUM_CLKS , ctrl->clks); + ret =clk_bulk_prepare_enable (QSPI_NUM_CLKS , ctrl->clks); +if (ret) +return ret; + +return dev_pm_opp_set_rate (dev, ctrl->last_speed *4 ); }static int __maybe_unused qcom_qspi_suspend (struct device *dev)
Signature · 1 line
2.27.0.383.g050319c2ae-goog
PATCH v2 2/2 spi: spi-qcom-qspi: Set an autosuspend delay of 250 ms
In reply to Douglas AndersonIn commit cff80645d6d3 ("spi: spi-qcom-qspi: Add interconnect support") the spi_geni_runtime_suspend() and spi_geni_runtime_resume() became a bit slower. Measuring on my hardware I see numbers in the hundreds of microseconds now.
Let's use autosuspend to help avoid some of the overhead. Now if we're doing a bunch of transfers we won't need to be constantly chruning.
The number 250 ms for the autosuspend delay was picked a bit arbitrarily, so if someone has measurements showing a better value we could easily change this.
---
This patch could go through the SPI tree or land in the Qualcomm tree. The patch it Fixes is currently in the Qualcomm tree so if it lands in the main SPI tree there'd be a bit of a perf regression in the Qualcomm tree until things merge together in mainline.
Changes in v2: None
drivers/spi/spi-qcom-qspi.c | 2 ++ 1 file changed, 2 insertions(+)
drivers/spi/spi-qcom-qspi.c +2 -0
@@ -553,6 +553,8 @@ static int qcom_qspi_probe(struct platform_device *pdev) goto exit_probe_master_put; } +pm_runtime_use_autosuspend (dev); +pm_runtime_set_autosuspend_delay (dev,250 );pm_runtime_enable (dev); ret =spi_register_master (master);
Signature · 1 line
2.27.0.383.g050319c2ae-goog
Quoted 20 lines · Douglas Anderson
Not to be confused with the similar series I posed for the _other_ Qualcomm SPI controller (spi-geni-qcom) [1], this one avoids the overhead on the Quad SPI controller.
It's based atop the current Qualcomm tree including Rajendra's ("spi:
spi-qcom-qspi: Use OPP API to set clk/perf state"). As discussed in individual patches, these could ideally land through the Qualcomm tree with Mark's Ack.Measuring:
* Before OPP / Interconnect patches reading all flash takes: ~3.4 seconds
* After OPP / Interconnect patches reading all flash takes: ~4.7 seconds
* After this patch reading all flash takes: ~3.3 seconds[1] https://lore.kernel.org/r/[email protected]
[2] https://lore.kernel.org/r/[email protected]Changes in v2:
- Return error from runtime resume ifdev_pm_opp_set_rate()fails.
Quoted 6 lines
Douglas Anderson (2):
spi: spi-qcom-qspi: Avoid clock setting if not needed
spi: spi-qcom-qspi: Set an autosuspend delay of 250 msdrivers/spi/spi-qcom-qspi.c | 43 ++++++++++++++++++++++++++++--------- 1 file changed, 33 insertions(+), 10 deletions(-)
Signature · 1 line
The Qualcomm Innovation Center, Inc. is a member of the Code Aurora Forum,\na Linux Foundation Collaborative Project