Skip to contentSkip to conversation

regulator: gpio: Honor regulator-boot-on property

PATCH In review Chen-Yu Tsai 2 participants 2 messages Jul 20, 2020 – Jul 22, 2020 Voltage and current regulator framework

lore
Share & tools
lore
#0 lore raw

PATCH v3 1/1 regulator: gpio: Honor regulator-boot-on property

From: Chen-Yu Tsai <[email protected]>

When requesting the enable GPIO, the driver should do so with the correct output level matching some expected state. This is especially important if the regulator is a critical one, such as a supply for the boot CPU. This is currently done by checking for the enable-at-boot property, but this is not documented in the device tree binding, nor does it match the common regulator properties.

Honor the common regulator-boot-on property by checking the boot_on constraint setting within the DT probe path. This is the same as what is done in the fixed regulator driver.

Also add a comment stating that the enable-at-boot property should not be used.

Fixes 006694d099e8 ("regulator: gpio-regulator: Allow use of GPIO controlled regulators though DT")

---
Changes since v2:
- Keep enable-at-boot property support
- Add comment stating enable-at-boot should not be used

Changes since v1:
- Reworded commit log
- Fixed typo in subject

---
 drivers/regulator/gpio-regulator.c | 7 +++++++
 1 file changed, 7 insertions(+)
drivers/regulator/gpio-regulator.c +7 -0
index 110ee6fe76c4..044e45ee9629 100644
@@ -148,6 +148,13 @@ of_get_gpio_regulator_config(struct device *dev, struct device_node *np,
 
 	config->supply_name = config->init_data->constraints.name;
 
+	if (config->init_data->constraints.boot_on)
+		config->enabled_at_boot = true;
+
+	/*
+	 * Do not use: undocumented device tree property.
+	 * This is kept around solely for device tree ABI stability.
+	 */
 	if (of_property_read_bool(np, "enable-at-boot"))
 		config->enabled_at_boot = true;
 
Signature · 1 line
2.27.0
maintainer
#1 lore raw
Quoted 8 lines · Chen-Yu Tsai

When requesting the enable GPIO, the driver should do so with the correct output level matching some expected state. This is especially important if the regulator is a critical one, such as a supply for the boot CPU. This is currently done by checking for the enable-at-boot property, but this is not documented in the device tree binding, nor does it match the common regulator properties.

[...]

Applied to

https://git.kernel.org/pub/scm/linux/kernel/git/broonie/regulator.git for-next

Thanks!

[1/1] regulator: gpio: Honor regulator-boot-on property

      commit: 3acff11cef1dece31cd29956f19181895996a7c5

All being well this means that it will be integrated into the linux-next tree (usually sometime in the next 24 hours) and sent to Linus during the next merge window (or sooner if it is a bug fix), however if problems are discovered then the patch may be dropped or reverted.

You may get further e-mails resulting from automated or manual testing and review of the tree, please engage with people reporting problems and send followup patches addressing any issues that are reported if needed.

If any updates are required or you are submitting further changes they should be sent as incremental updates against current git, existing patches will not be replaced.

Please add any relevant lists and maintainers to the CCs when replying to this mail.

Thanks,
Mark