Skip to contentSkip to conversation

mixing raid1 and raid0?

DISCUSSION Eric Wong 2 participants 2 messages Jul 25, 2020 Btrfs file system

lore
Share & tools
lore

Eric Wong

author
#0 lore raw

Hey all, I've started using btrfs recently with old HDDs of various sizes in a btrfs raid1 pool. It seems pretty good from a flexibility and redundancy standpoint.

However, things like temporary files, caches, etc. don't need to be raid1, and raid0 might allow me to reduce wear on HDDs; so I'd like to make part of it raid0 while keeping most of it raid1.

If my btrfs is mounted as /mnt/btrfs, would the following do what I want?

btrfs balance start -dconvert=raid1 -mconvert=raid1 /mnt/btrfs/precious btrfs balance start -dconvert=raid0 -mconvert=raid0 /mnt/btrfs/junk

Or should I make a separate FS for temporary and disposable raid0 data?

Thanks

#1 lore raw

25.07.2020 09:02, Eric Wong пишет:

Quoted 11 lines

Hey all, I've started using btrfs recently with old HDDs of various sizes in a btrfs raid1 pool. It seems pretty good from a flexibility and redundancy standpoint.

However, things like temporary files, caches, etc. don't need to be raid1, and raid0 might allow me to reduce wear on HDDs; so I'd like to make part of it raid0 while keeping most of it raid1.

If my btrfs is mounted as /mnt/btrfs, would the following do what I want?

Quoted 8 lines

btrfs balance start -dconvert=raid1 -mconvert=raid1 /mnt/btrfs/precious btrfs balance start -dconvert=raid0 -mconvert=raid0 /mnt/btrfs/junk

Or should I make a separate FS for temporary and disposable raid0 data?

Thanks

Balance does not work on logical directory or subvolume level. Even if it did, btrfs filesystem has only one target profile and it is the last one used (i.e. the target profile of the last convert). So any new writes after the last balance command would be using raid0 profile everywhere.

Different allocation profiles for different subvolumes comes pretty regular as wish list.

So you in your case you will need separate filesytem.