configs: pico-imx6: convert ethernet function to DM_ETH
PATCH 1/1 configs: pico-imx6: convert ethernet function to DM_ETH
From: Wig Cheng <[email protected]>
Before enable _DM_ETH:
Net: FEC [PRIME]
After enable DM_ETH:
Net: eth0: ethernet at 2188000
Here is the test commands:
=> dhcp
BOOTP broadcast 1
DHCP client bound to address 10.88.88.152 (146 ms) *** ERROR: `serverip' not set
Cannot autoload with TFTPGET
=> ping 8.8.8.8
Using ethernet at 2188000 device
host 8.8.8.8 is alive
--- configs/pico-imx6_defconfig | 3 +++ 1 file changed, 3 insertions(+)
configs/pico-imx6_defconfig +3 -0
@@ -64,6 +64,9 @@ CONFIG_DM_MMC=y CONFIG_FSL_USDHC=y CONFIG_PHYLIB=y CONFIG_PHY_ATHEROS=y +CONFIG_DM_ETH=y +CONFIG_DM_MDIO=y +CONFIG_RGMII=y CONFIG_PINCTRL=y CONFIG_PINCTRL_IMX6=y CONFIG_MXC_UART=y
Signature · 1 line
2.17.1
PATCH 1/1 configs: pico-imx6: convert ethernet function to DM_ETH
Quoted 14 lines
From: Wig Cheng <[email protected]>
Before enable_DM_ETH:
Net: FEC [PRIME]
After enableDM_ETH:Net: eth0: ethernet at 2188000Here is the test commands:
=> dhcp
BOOTP broadcast 1
DHCP client bound to address 10.88.88.152 (146 ms) *** ERROR: `serverip' not set
Cannot autoload with TFTPGET
=> ping 8.8.8.8
Using ethernet at 2188000 device
host 8.8.8.8 is alive
Quoted 1 line
Signed-off-by Wig Cheng <[email protected]>
Applied to u-boot-imx, master, thanks !
Best regards,
Stefano Babic
Signature · 5 lines
===================================================================== DENX Software Engineering GmbH, Managing Director: Wolfgang Denk HRB 165235 Munich, Office: Kirchenstr.5, D-82194 Groebenzell, Germany Phone: +49-8142-66989-53 Fax: +49-8142-66989-80 Email: sbabic at denx.de =====================================================================