Skip to contentSkip to conversation

net: macb: Properly handle phylink on at91sam9x

PATCH In review Stefan Roese 2 participants 2 messages Aug 4, 2020

Subsystems (3)
lore
Share & tools
lore
#0 lore raw

PATCH 1/1 net: macb: Properly handle phylink on at91sam9x

I just recently noticed that ethernet does not work anymore since v5.5 on the GARDENA smart Gateway, which is based on the AT91SAM9G25. Debugging showed that the "GEM bits" in the NCFGR register are now unconditionally accessed, which is incorrect for the !macb_is_gem() case.

This patch adds the macb_is_gem() checks back to the code (in macb_mac_config() & macb_mac_link_up()), so that the GEM register bits are not accessed in this case any more.

Fixes 7897b071ac3b ("net: macb: convert to phylink")
Cc Reto Schneider <[email protected]>
Cc Alexandre Belloni <[email protected]>
Cc Nicolas Ferre <[email protected]>
Cc David S. Miller <[email protected]>
---
 drivers/net/ethernet/cadence/macb_main.c | 11 +++++++----
 1 file changed, 7 insertions(+), 4 deletions(-)
drivers/net/ethernet/cadence/macb_main.c +7 -4
index 2213e6ab8151..4b1b5928b104 100644
@@ -578,7 +578,7 @@ static void macb_mac_config(struct phylink_config *config, unsigned int mode,
 	if (bp->caps & MACB_CAPS_MACB_IS_EMAC) {
 		if (state->interface == PHY_INTERFACE_MODE_RMII)
 			ctrl |= MACB_BIT(RM9200_RMII);
-	} else {
+	} else if (macb_is_gem(bp)) {
 		ctrl &= ~(GEM_BIT(SGMIIEN) | GEM_BIT(PCSSEL));
 
 		if (state->interface == PHY_INTERFACE_MODE_SGMII)
@@ -639,10 +639,13 @@ static void macb_mac_link_up(struct phylink_config *config,
 		ctrl |= MACB_BIT(FD);
 
 	if (!(bp->caps & MACB_CAPS_MACB_IS_EMAC)) {
-		ctrl &= ~(GEM_BIT(GBE) | MACB_BIT(PAE));
+		ctrl &= ~MACB_BIT(PAE);
+		if (macb_is_gem(bp)) {
+			ctrl &= ~GEM_BIT(GBE);
 
-		if (speed == SPEED_1000)
-			ctrl |= GEM_BIT(GBE);
+			if (speed == SPEED_1000)
+				ctrl |= GEM_BIT(GBE);
+		}
 
 		/* We do not support MLO_PAUSE_RX yet */
 		if (tx_pause)
Signature · 7 lines
2.28.0


_______________________________________________
linux-arm-kernel mailing list
[email protected]
http://lists.infradead.org/mailman/listinfo/linux-arm-kernel
maintainer
#1 lore raw

From: Stefan Roese <[email protected]>
Date: Tue, 4 Aug 2020 14:17:16 +0200

Quoted 6 lines

I just recently noticed that ethernet does not work anymore since v5.5 on the GARDENA smart Gateway, which is based on the AT91SAM9G25. Debugging showed that the "GEM bits" in the NCFGR register are now unconditionally accessed, which is incorrect for the !macb_is_gem() case.

Quoted 6 lines

This patch adds the macb_is_gem() checks back to the code (in macb_mac_config() & macb_mac_link_up()), so that the GEM register bits are not accessed in this case any more.

Fixes 7897b071ac3b ("net: macb: convert to phylink")

Applied and queued up for -stable, thanks.