doc: qemu: debug UART settings for QEMU ARM virt
PATCH 1/1 doc: qemu: debug UART settings for QEMU ARM virt
Provide the settings for the debug UART on the QEMU ARM virt board.
Signed-off-by Heinrich Schuchardt <[email protected]>
--- doc/board/emulation/qemu-arm.rst | 10 ++++++++++ 1 file changed, 10 insertions(+)
doc/board/emulation/qemu-arm.rst +10 -0
@@ -80,3 +80,13 @@ can be enabled with the following command line parameters: -drive if=none,file=disk.img,id=mydisk -device nvme,drive=mydisk,serial=foo These have been tested in QEMU 2.9.0 but should work in at least 2.5.0 as well. + +Debug UART +---------- + +The debug UART on the ARM virt board uses these settings:: + + CONFIG_DEBUG_UART=y + CONFIG_DEBUG_UART_PL010=y + CONFIG_DEBUG_UART_BASE=0x9000000 + CONFIG_DEBUG_UART_CLOCK=0
--
2.28.0
PATCH 1/1 doc: qemu: debug UART settings for QEMU ARM virt
Quoted 3 lines · Heinrich Schuchardt
Provide the settings for the debug UART on the QEMU ARM virt board.
Signed-off-by Heinrich Schuchardt <[email protected]>
Applied to u-boot/master, thanks!
Signature · 8 lines
Tom -------------- next part -------------- A non-text attachment was scrubbed... Name: signature.asc Type: application/pgp-signature Size: 659 bytes Desc: not available URL: <https://lists.denx.de/pipermail/u-boot/attachments/20200917/86bf0278/attachment.sig>