Skip to contentSkip to conversation

check: try reloading modules

PATCH New Darrick J. Wong 1 participant 1 message Sep 18, 2020

lore
Share & tools
lore
#0 lore raw

PATCH v2 24/24 check: try reloading modules

From: Darrick J. Wong <[email protected]>

Optionally reload the module between each test to try to pinpoint slab cache errors and whatnot.

---
v2: use "fs-$FSTYP" for the module name

---
 README |    3 +++
 check  |    9 +++++++++
 2 files changed, 12 insertions(+)
README +3 -0
index d0e23fcd..4af331b4 100644
@@ -106,6 +106,9 @@ Preparing system for tests:
              - set USE_KMEMLEAK=yes to scan for memory leaks in the kernel
                after every test, if the kernel supports kmemleak.
              - set KEEP_DMESG=yes to keep dmesg log after test
+             - Set TEST_FS_MODULE_RELOAD=1 to unload the module and reload
+               it between test invocations.  This assumes that the name of
+               the module is the same as FSTYP.
 
         - or add a case to the switch in common/config assigning
           these variables based on the hostname of your test
check +9 -0
index 6a353399..6002233a 100755
@@ -834,6 +834,15 @@ function run_section()
 			_check_dmesg || err=true
 		fi
 
+		# Reload the module after each test to check for leaks or
+		# other problems.
+		if [ -n "${TEST_FS_MODULE_RELOAD}" ]; then
+			_test_unmount 2> /dev/null
+			_scratch_unmount 2> /dev/null
+			modprobe -r fs-$FSTYP
+			modprobe fs-$FSTYP
+		fi
+
 		# Scan for memory leaks after every test so that associating
 		# a leak to a particular test will be as accurate as possible.
 		_check_kmemleak || err=true