dmaengine: ti: k3-udma-glue: fix channel enable functions
PATCH v2 1/1 dmaengine: ti: k3-udma-glue: fix channel enable functions
Quoted 10 lines · Grygorii Strashko
Now the K3 UDMA glue layer enable functions perform RMW operation on UDMA RX/TX
RT_CTLregisters to set EN bit and enable channel, which is incorrect, because only EN bit has to be set in those registers to enable channel (all other bits should be cleared 0).
More over, this causes issues when bootloader leaves UDMA channel RX/TXRT_CTLregisters in incorrect state - TDOWN bit set, for example. As result, UDMA channel will just perform teardown right after it's enabled.Hence, fix it by writing correct values (EN=1) directly in UDMA channel RX/TX
RT_CTLregisters in k3_udma_glue_enable_tx/rx_chn() functions.
Applied, thanks
Signature · 1 line
~Vinod