pwm: Add driver for Amlogic Meson PWM controller
Subsystems (2)
PATCH 1/1 pwm: Add driver for Amlogic Meson PWM controller
This adds the driver for the PWM controller found in the Amlogic SoCs.
This PWM is only a set of Gates, Dividers and Counters:
PWM output is achieved by calculating a clock that permits calculating two periods (low and high). The counter then has to be set to switch after N cycles for the first half period.
The hardware has no "polarity" setting. This driver reverses the period cycles (the low length is inverted with the high length) for PWM_POLARITY_INVERSED.
Disabling the PWM stops the output immediately (without waiting for the current period to complete first).
Signed-off-by Neil Armstrong <[email protected]>
--- drivers/pwm/Kconfig | 7 + drivers/pwm/Makefile | 1 + drivers/pwm/pwm-meson.c | 528 ++++++++++++++++++++++++++++++++++++++++ 3 files changed, 536 insertions(+) create mode 100644 drivers/pwm/pwm-meson.c
drivers/pwm/Kconfig +7 -0
@@ -23,6 +23,13 @@ config PWM_IMX help This PWM is found i.MX27 and later i.MX SoCs. +config PWM_MESON + bool "Enable support for Amlogic Meson SoCs PWM" + depends on DM_PWM + help + This PWM is found on Amlogic Meson SoCs. It supports a + programmable period and duty cycle for 2 independant channels. + config PWM_MTK bool "Enable support for MediaTek PWM" depends on DM_PWM
drivers/pwm/Makefile +1 -0
@@ -12,6 +12,7 @@ obj-$(CONFIG_DM_PWM) += pwm-uclass.o obj-$(CONFIG_PWM_EXYNOS) += exynos_pwm.o obj-$(CONFIG_PWM_IMX) += pwm-imx.o pwm-imx-util.o +obj-$(CONFIG_PWM_MESON) += pwm-meson.o obj-$(CONFIG_PWM_MTK) += pwm-mtk.o obj-$(CONFIG_PWM_ROCKCHIP) += rk_pwm.o obj-$(CONFIG_PWM_SANDBOX) += sandbox_pwm.o
drivers/pwm/pwm-meson.c new file +528 -0
528 lines not on this page · raw message
Signature · 1 line
2.25.1