qla2xxx: Return EBUSY on fcport deletion
Subsystems (2)
PATCH v2 1/1 qla2xxx: Return EBUSY on fcport deletion
When the fcport is about to be deleted we should return EBUSY instead of ENODEV. Only for EBUSY the request will be requeued in a multipath setup.
Also in case we have a valid qpair but the firmware has not yet started return EBUSY to avoid dropping the request.
---
v2: rebased on mkp/staging
drivers/scsi/qla2xxx/qla_nvme.c | 5 ++++- 1 file changed, 4 insertions(+), 1 deletion(-)
drivers/scsi/qla2xxx/qla_nvme.c +4 -1
@@ -555,8 +555,11 @@ static int qla_nvme_post_cmd(struct nvme_fc_local_port *lport, fcport = qla_rport->fcport; -if (!qpair || !fcport || (qpair && !qpair->fw_started) || +if ((qpair && !qpair->fw_started) || (fcport && fcport->deleted)) +return -EBUSY ; + +if (!qpair || !fcport)return -ENODEV ; vha = fcport->vha;
Signature · 1 line
2.16.4
Quoted 23 lines · Daniel Wagner
When the fcport is about to be deleted we should return EBUSY instead of ENODEV. Only for EBUSY the request will be requeued in a multipath setup.
Also in case we have a valid qpair but the firmware has not yet started return EBUSY to avoid dropping the request.
Signed-off-by Daniel Wagner <[email protected]>---
v2: rebased on mkp/staging
drivers/scsi/qla2xxx/qla_nvme.c | 5 ++++- 1 file changed, 4 insertions(+), 1 deletion(-)drivers/scsi/qla2xxx/qla_nvme.c +0
-0@@ -555,8 +555,11 @@ static int qla_nvme_post_cmd(struct nvme_fc_local_port *lport, fcport = qla_rport->fcport;
drivers/scsi/qla2xxx/qla_nvme.c static int qla_nvme_post_cmd(struct nvme_fc_local_port *lport, · line 565
Quoted 10 lines
drivers/scsi/qla2xxx/qla_nvme.c +4
-1-if (!qpair || !fcport || (qpair && !qpair->fw_started) || +if ((qpair && !qpair->fw_started) || (fcport && fcport->deleted)) +return -EBUSY ; + +if (!qpair || !fcport)return -ENODEV ; vha = fcport->vha;
Please move up the "(!qpair || !fcport)" check; you can avoid the qpair/fcport check in the first "if" condition, then.
Regards,
-Arun