net: stmmac: dwmac-meson8b: remove unneeded semicolon
Subsystems (5)
PATCH 1/1 net: stmmac: dwmac-meson8b: remove unneeded semicolon
From: Tom Rix <[email protected]>
A semicolon is not needed after a switch statement.
Signed-off-by Tom Rix <[email protected]>
--- drivers/net/ethernet/stmicro/stmmac/dwmac-meson8b.c | 2 +- 1 file changed, 1 insertion(+), 1 deletion(-)
drivers/net/ethernet/stmicro/stmmac/dwmac-meson8b.c +1 -1
@@ -299,7 +299,7 @@ static int meson8b_init_prg_eth(struct meson8b_dwmac *dwmac)dev_err (dwmac->dev,"unsupported phy-mode %s\n" ,phy_modes (dwmac->phy_mode));return -EINVAL ; - }; + }if (rx_dly_config &PRG_ETH0_ADJ_ENABLE ) {if (!dwmac->timing_adj_clk) {
Signature · 1 line
2.18.1
Quoted 5 lines · On Sun, 1 Nov 2020 06:07:20 -0800 [email protected] wrote:
From: Tom Rix <[email protected]>
A semicolon is not needed after a switch statement.
Signed-off-by Tom Rix <[email protected]>
Applied..