Skip to contentSkip to conversation

AER: aer_root_reset() non-native handling

PATCH Superseded Sean V Kelley 1 participant 1 message Nov 4, 2020

Subsystems (2)

v2 of 3 Superseded Latest is v3 →

lore
Share & tools
lore
#0 lore raw

PATCH v2 1/1 AER: aer_root_reset() non-native handling

If an OS has not been granted AER control via _OSC, then the OS should not make changes to PCI_ERR_ROOT_COMMAND and PCI_ERR_ROOT_STATUS related registers. Per section 4.5.1 of the System Firmware Intermediary (SFI) _OSC and DPC Updates ECN [1], this bit also covers these aspects of the PCI Express Advanced Error Reporting. Based on the above and earlier discussion [2], make the following changes:

Add a check for the native case (i.e., AER control via _OSC)

Note that the current "clear, reset, enable" order suggests that the reset might cause errors that we should ignore. Lacking historical context, these will be retained.

[1] System Firmware Intermediary (SFI) _OSC and DPC Updates ECN, Feb 24, 2020, affecting PCI Firmware Specification, Rev. 3.2
https://members.pcisig.com/wg/PCI-SIG/document/14076
[2] https://lore.kernel.org/linux-pci/20201020162820.GA370938@bjorn-Precision-5520/

---
Changes since V1 [1]:

Noted lack of historical context on isolation of both the pci_bus_error_reset() and the clearing of Root Error Status. In fact, the call to aer_enable_rootport() likewise disables system error generation in response to error messages around the clearing of the error status. So retained the wrapping of the "clear, reset, enable".

[1] https://lore.kernel.org/linux-pci/[email protected]/

Thanks,

Sean

---
 drivers/pci/pcie/aer.c | 31 +++++++++++++++++--------------
 1 file changed, 17 insertions(+), 14 deletions(-)
drivers/pci/pcie/aer.c +17 -14
index 65dff5f3457a..6d4f70ec8546 100644
@@ -1358,26 +1358,29 @@ static int aer_probe(struct pcie_device *dev)
 static pci_ers_result_t aer_root_reset(struct pci_dev *dev)
 {
 	int aer = dev->aer_cap;
+	int rc = 0;
 	u32 reg32;
-	int rc;
-
 
-	/* Disable Root's interrupt in response to error messages */
-	pci_read_config_dword(dev, aer + PCI_ERR_ROOT_COMMAND, &reg32);
-	reg32 &= ~ROOT_PORT_INTR_ON_MESG_MASK;
-	pci_write_config_dword(dev, aer + PCI_ERR_ROOT_COMMAND, reg32);
+	if (pcie_aer_is_native(dev)) {
+		/* Disable Root's interrupt in response to error messages */
+		pci_read_config_dword(root, aer + PCI_ERR_ROOT_COMMAND, &reg32);
+		reg32 &= ~ROOT_PORT_INTR_ON_MESG_MASK;
+		pci_write_config_dword(root, aer + PCI_ERR_ROOT_COMMAND, reg32);
+	}
 
 	rc = pci_bus_error_reset(dev);
-	pci_info(dev, "Root Port link has been reset\n");
+	pci_info(dev, "Root Port link has been reset (%d)\n", rc);
 
-	/* Clear Root Error Status */
-	pci_read_config_dword(dev, aer + PCI_ERR_ROOT_STATUS, &reg32);
-	pci_write_config_dword(dev, aer + PCI_ERR_ROOT_STATUS, reg32);
+	if (pcie_aer_is_native(dev)) {
+		/* Clear Root Error Status */
+		pci_read_config_dword(root, aer + PCI_ERR_ROOT_STATUS, &reg32);
+		pci_write_config_dword(root, aer + PCI_ERR_ROOT_STATUS, reg32);
 
-	/* Enable Root Port's interrupt in response to error messages */
-	pci_read_config_dword(dev, aer + PCI_ERR_ROOT_COMMAND, &reg32);
-	reg32 |= ROOT_PORT_INTR_ON_MESG_MASK;
-	pci_write_config_dword(dev, aer + PCI_ERR_ROOT_COMMAND, reg32);
+		/* Enable Root Port's interrupt in response to error messages */
+		pci_read_config_dword(root, aer + PCI_ERR_ROOT_COMMAND, &reg32);
+		reg32 |= ROOT_PORT_INTR_ON_MESG_MASK;
+		pci_write_config_dword(root, aer + PCI_ERR_ROOT_COMMAND, reg32);
+	}
 
 	return rc ? PCI_ERS_RESULT_DISCONNECT : PCI_ERS_RESULT_RECOVERED;
 }

--
2.29.2