dt-bindings: fsl: add kamstrup flex concentrator to schema
Subsystems (3)
PATCH v4 1/2 dt-bindings: fsl: add kamstrup flex concentrator to schema
Add Kamstrup OMNIA Flex Concentrator compatibles to the schema so we can make use of them for the validation.
---
Changes since version 3:
- Rebase patch to v5.10-rc4.
No changes since version 2.
Changes since version 1:
- Patch prefix renamed to "dt-bindings: fsl:"
- Added acked-by from Rob Herring.
- Fixed typo in commit message.
Documentation/devicetree/bindings/arm/fsl.yaml | 2 ++ 1 file changed, 2 insertions(+)
Documentation/devicetree/bindings/arm/fsl.yaml +2 -0
@@ -362,6 +362,8 @@ properties: - enum: - fsl,imx7d-sdb # i.MX7 SabreSD Board - fsl,imx7d-sdb-reva # i.MX7 SabreSD Rev-A Board + - kam,imx7d-flex-concentrator # Kamstrup OMNIA Flex Concentrator + - kam,imx7d-flex-concentrator-mfg # Kamstrup OMNIA Flex Concentrator in manufacturing mode - novtech,imx7d-meerkat96 # i.MX7 Meerkat96 Board - technexion,imx7d-pico-dwarf # TechNexion i.MX7D Pico-Dwarf - technexion,imx7d-pico-hobbit # TechNexion i.MX7D Pico-Hobbit
base-commit: 09162bc32c880a791c6c0668ce0745cf7958f576
Signature · 1 line
2.28.0
PATCH v4 2/2 ARM: dts: imx7: add support for kamstrup flex concentrator
This adds support for the OMNIA Flex Concentrator product from Kamstrup A/S. It's providing radio mesh communication infrastructure for smart electricity meters.
Kamstrup OMNIA is a modular and scalable smart grid platform.
---
Thanks for v3 review Shawn Guo.
Changes since version 3:
- Removed "kam,imx7d-flex-concentrator" from compatible in mfg dts.
- Changed hmi-{b,c,d}-{red,green} to led-{0,1,2,3,4,5}.
- Removed 'default-state = "off"' as that is already default.
- Added heartbeat trigger on led-1.
- Updated gpio-leds labels.
- Added over-current-active-low in usbotg2.
- Don't delete m24c64 EEPROM node as TQ is unable to manufacture modules without it.
Changes since version 2:
- Found root cause of Ethernet PHY auto detect issue and created a mdio patch series that resolves the issue.
https://lore.kernel.org/netdev/[email protected]/
- Ethernet PHY reset is using new MDIO bus reset.
- Ethernet PHY interrupt added.
- Removed SION from a few GPIOs used for Ethernet PHY.
Changes since version 1:
- Sorted labeling nodes.
- Sorted pinctrl entries.
- Removed deprecated fec phy reset properties.
- Added mdio phy reset properties.
- Disabled phy type auto detection and added note to commit message.
- Fixed two comment typos.
arch/arm/boot/dts/Makefile | 2 + .../boot/dts/imx7d-flex-concentrator-mfg.dts | 25 ++ arch/arm/boot/dts/imx7d-flex-concentrator.dts | 314 ++++++++++++++++++ 3 files changed, 341 insertions(+) create mode 100644 arch/arm/boot/dts/imx7d-flex-concentrator-mfg.dts create mode 100644 arch/arm/boot/dts/imx7d-flex-concentrator.dts
arch/arm/boot/dts/Makefile +2 -0
@@ -641,6 +641,8 @@ dtb-$(CONFIG_SOC_IMX7D) += \ imx7d-colibri-emmc-aster.dtb \ imx7d-colibri-emmc-eval-v3.dtb \ imx7d-colibri-eval-v3.dtb \ + imx7d-flex-concentrator.dtb \ + imx7d-flex-concentrator-mfg.dtb \ imx7d-mba7.dtb \ imx7d-meerkat96.dtb \ imx7d-nitrogen7.dtb \
arch/arm/boot/dts/imx7d-flex-concentrator-mfg.dts new file +25 -0
@@ -0,0 +1,25 @@ +// SPDX-License-Identifier: GPL-2.0 +/* + * Device Tree Source for Kamstrup OMNIA Flex Concentrator in + * manufacturing/debugging mode. + * + * Copyright (C) 2020 Kamstrup A/S + * Author: Bruno Thomsen <[email protected]> + */ + +/dts-v1/; + +#include "imx7d-flex-concentrator.dts" + +/ { + model = "Kamstrup OMNIA Flex Concentrator - Manufacturing"; + compatible = "kam,imx7d-flex-concentrator-mfg", "fsl,imx7d"; + + chosen { + stdout-path = &uart4; + }; +}; + +&uart4 { + status = "okay"; +};
arch/arm/boot/dts/imx7d-flex-concentrator.dts new file +314 -0
314 lines not on this page · raw message
Signature · 1 line
2.28.0
Shawn Guo
AppliedQuoted 5 lines · Bruno Thomsen
Add Kamstrup OMNIA Flex Concentrator compatibles to the schema so we can make use of them for the validation.
Signed-off-by Bruno Thomsen <[email protected]>Acked-by Rob Herring <[email protected]>
Applied both, thanks.