Skip to contentSkip to conversation

ARM: dts: sun7i: pcduino3-nano: enable RGMII RX/TX delay on PHY

PATCH Applied Adam Sampson 2 participants 2 messages Nov 23, 2020 – Nov 24, 2020

Subsystems (2)
lore
Share & tools
lore
#0 lore raw

PATCH 1/1 ARM: dts: sun7i: pcduino3-nano: enable RGMII RX/TX delay on PHY

The RX/TX delays for the Ethernet PHY on the Linksprite pcDuino 3 Nano are configured in hardware, using resistors that are populated to pull the RTL8211E's RXDLY/TXDLY pins low or high as needed.

phy-mode should be set to rgmii-id to reflect this. Previously it was set to rgmii, which used to work but now results in the delays being disabled again as a result of the bugfix in commit bbc4d71d6354 ("net:
phy: realtek: fix rtl8211e rx/tx delay config").

Tested on two pcDuino 3 Nano boards purchased in 2015. Without this fix, Ethernet works unreliably on one board and doesn't work at all on the other.

Fixes 061035d456c9 ("ARM: dts: sun7i: Add dts file for pcDuino 3 Nano board")
---
 arch/arm/boot/dts/sun7i-a20-pcduino3-nano.dts | 4 ++--
 1 file changed, 2 insertions(+), 2 deletions(-)
arch/arm/boot/dts/sun7i-a20-pcduino3-nano.dts +2 -2
index fce2f7fcd084..bf38c66c1815 100644
@@ -1,5 +1,5 @@
 /*
- * Copyright 2015 Adam Sampson <[email protected]>
+ * Copyright 2015-2020 Adam Sampson <[email protected]>
  *
  * This file is dual-licensed: you can use it either under the terms
  * of the GPL or the X11 license, at your option. Note that this dual
@@ -115,7 +115,7 @@ &gmac {
 	pinctrl-names = "default";
 	pinctrl-0 = <&gmac_rgmii_pins>;
 	phy-handle = <&phy1>;
-	phy-mode = "rgmii";
+	phy-mode = "rgmii-id";
 	status = "okay";
 };
 
Signature · 1 line
2.29.1
#1 lore raw
Quoted 9 lines · Adam Sampson

The RX/TX delays for the Ethernet PHY on the Linksprite pcDuino 3 Nano are configured in hardware, using resistors that are populated to pull the RTL8211E's RXDLY/TXDLY pins low or high as needed.

phy-mode should be set to rgmii-id to reflect this. Previously it was set to rgmii, which used to work but now results in the delays being disabled again as a result of the bugfix in commit bbc4d71d6354 ("net:
phy: realtek: fix rtl8211e rx/tx delay config").

Quoted 8 lines

Tested on two pcDuino 3 Nano boards purchased in 2015. Without this fix, Ethernet works unreliably on one board and doesn't work at all on the other.

Fixes 061035d456c9 ("ARM: dts: sun7i: Add dts file for pcDuino 3 Nano board")

Applied, thanks
Maxime