ARM: dts: sun8i-h2-plus-bananapi-m2-zero: add regulator nodes vcc-dram and vcc1v2
Subsystems (2)
PATCH 1/1 ARM: dts: sun8i-h2-plus-bananapi-m2-zero: add regulator nodes vcc-dram and vcc1v2
Add regulator nodes vcc-dram and vcc1v2 to the devicetree. These regulators correspond to U4 and U5 in the schematics:
http://forum.banana-pi.org/t/bpi-m2-zero-schematic-diagram-public/4111
Signed-off-by Michael Klein <[email protected]>
--- .../dts/sun8i-h2-plus-bananapi-m2-zero.dts | 24 +++++++++++++++++++ 1 file changed, 24 insertions(+)
arch/arm/boot/dts/sun8i-h2-plus-bananapi-m2-zero.dts +24 -0
@@ -62,6 +62,30 @@ reg_vdd_cpux: vdd-cpux-regulator { states = <1100000 0>, <1300000 1>; }; + reg_vcc_dram: vcc-dram { + compatible = "regulator-fixed"; + regulator-name = "vcc-dram"; + regulator-min-microvolt = <1500000>; + regulator-max-microvolt = <1500000>; + regulator-always-on; + regulator-boot-on; + enable-active-high; + gpio = <&r_pio 0 9 GPIO_ACTIVE_HIGH>; /* PL9 */ + vin-supply = <®_vcc5v0>; + }; + + reg_vcc1v2: vcc1v2 { + compatible = "regulator-fixed"; + regulator-name = "vcc1v2"; + regulator-min-microvolt = <1200000>; + regulator-max-microvolt = <1200000>; + regulator-always-on; + regulator-boot-on; + enable-active-high; + gpio = <&r_pio 0 8 GPIO_ACTIVE_HIGH>; /* PL8 */ + vin-supply = <®_vcc5v0>; + }; + wifi_pwrseq: wifi_pwrseq { compatible = "mmc-pwrseq-simple"; reset-gpios = <&r_pio 0 7 GPIO_ACTIVE_LOW>; /* PL7 */
Signature · 1 line
2.29.2
Maxime Ripard
AppliedQuoted 6 lines · Michael Klein
Add regulator nodes vcc-dram and vcc1v2 to the devicetree. These regulators correspond to U4 and U5 in the schematics:
http://forum.banana-pi.org/t/bpi-m2-zero-schematic-diagram-public/4111
Signed-off-by Michael Klein <[email protected]>
Queued for 5.12, thanks!
Maxime