Documentation: media: Update pixel rate formula for C-PHY
PATCH 1/1 Documentation: media: Update pixel rate formula for C-PHY
Update the formula to calculate the pixel rate on the link for C-PHY.
Signed-off-by Sakari Ailus <[email protected]>
--- Documentation/driver-api/media/csi2.rst | 4 +++- 1 file changed, 3 insertions(+), 1 deletion(-)
Documentation/driver-api/media/csi2.rst +3 -1
@@ -35,7 +35,7 @@ ability to start and stop the stream. The value of the V4L2_CID_PIXEL_RATE is calculated as follows:: - pixel_rate = link_freq * 2 * nr_of_lanes / bits_per_sample + pixel_rate = link_freq * 2 * nr_of_lanes * 16 / k / bits_per_sample where
@@ -53,6 +53,8 @@ where - Two bits are transferred per clock cycle per lane. * - bits_per_sample - Number of bits per sample. + * - k + - 16 for D-PHY and 7 for C-PHY The transmitter drivers must, if possible, configure the CSI-2 transmitter to *LP-11 mode* whenever the transmitter is powered on but
Signature · 1 line
2.29.2