Skip to contentSkip to conversation

ath10k: Remove voltage regulator votes during wifi disable

PATCH In review Rakesh Pillai 2 participants 3 messages Dec 11, 2020 – Dec 17, 2020 Qualcomm Atheros ATH10K wireless driver

lore
Share & tools
lore
#0 lore raw

PATCH v2 1/1 ath10k: Remove voltage regulator votes during wifi disable

When the wlan is disabled, i.e when all the interfaces are deleted, voltage regulator votes are not removed. This leads to more power consumption even when wlan is disabled.

Move the adding/removing of voltage regulator votes as part of hif power on/off in SNOC targets, so that these voltage regulator votes are there only when wlan is enabled.

Tested-on: WCN3990 hw1.0 SNOC WLAN.HL.3.1-01040-QCAHLSWMTPLZ-1

---
Changes from v1:
- Remove the CE pipe init failure handling. Posted as a different patch

---
 drivers/net/wireless/ath/ath10k/snoc.c | 92 +++++++++++++++++-----------------
 1 file changed, 46 insertions(+), 46 deletions(-)
drivers/net/wireless/ath/ath10k/snoc.c +46 -46
index daae470..a5443fb 100644
@@ -1003,6 +1003,39 @@ static int ath10k_snoc_wlan_enable(struct ath10k *ar,
 				       NULL);
 }
 
+static int ath10k_hw_power_on(struct ath10k *ar)
+{
+	struct ath10k_snoc *ar_snoc = ath10k_snoc_priv(ar);
+	int ret;
+
+	ath10k_dbg(ar, ATH10K_DBG_SNOC, "soc power on\n");
+
+	ret = regulator_bulk_enable(ar_snoc->num_vregs, ar_snoc->vregs);
+	if (ret)
+		return ret;
+
+	ret = clk_bulk_prepare_enable(ar_snoc->num_clks, ar_snoc->clks);
+	if (ret)
+		goto vreg_off;
+
+	return ret;
+
+vreg_off:
+	regulator_bulk_disable(ar_snoc->num_vregs, ar_snoc->vregs);
+	return ret;
+}
+
+static int ath10k_hw_power_off(struct ath10k *ar)
+{
+	struct ath10k_snoc *ar_snoc = ath10k_snoc_priv(ar);
+
+	ath10k_dbg(ar, ATH10K_DBG_SNOC, "soc power off\n");
+
+	clk_bulk_disable_unprepare(ar_snoc->num_clks, ar_snoc->clks);
+
+	return regulator_bulk_disable(ar_snoc->num_vregs, ar_snoc->vregs);
+}
+
 static void ath10k_snoc_wlan_disable(struct ath10k *ar)
 {
 	struct ath10k_snoc *ar_snoc = ath10k_snoc_priv(ar);
@@ -1024,6 +1057,7 @@ static void ath10k_snoc_hif_power_down(struct ath10k *ar)
 
 	ath10k_snoc_wlan_disable(ar);
 	ath10k_ce_free_rri(ar);
+	ath10k_hw_power_off(ar);
 }
 
 static int ath10k_snoc_hif_power_up(struct ath10k *ar,
@@ -1034,10 +1068,16 @@ static int ath10k_snoc_hif_power_up(struct ath10k *ar,
 	ath10k_dbg(ar, ATH10K_DBG_SNOC, "%s:WCN3990 driver state = %d\n",
 		   __func__, ar->state);
 
+	ret = ath10k_hw_power_on(ar);
+	if (ret) {
+		ath10k_err(ar, "failed to power on device: %d\n", ret);
+		return ret;
+	}
+
 	ret = ath10k_snoc_wlan_enable(ar, fw_mode);
 	if (ret) {
 		ath10k_err(ar, "failed to enable wcn3990: %d\n", ret);
-		return ret;
+		goto err_hw_power_off;
 	}
 
 	ath10k_ce_alloc_rri(ar);
@@ -1054,6 +1094,9 @@ static int ath10k_snoc_hif_power_up(struct ath10k *ar,
 	ath10k_ce_free_rri(ar);
 	ath10k_snoc_wlan_disable(ar);
 
+err_hw_power_off:
+	ath10k_hw_power_off(ar);
+
 	return ret;
 }
 
@@ -1370,39 +1413,6 @@ static void ath10k_snoc_release_resource(struct ath10k *ar)
 		ath10k_ce_free_pipe(ar, i);
 }
 
-static int ath10k_hw_power_on(struct ath10k *ar)
-{
-	struct ath10k_snoc *ar_snoc = ath10k_snoc_priv(ar);
-	int ret;
-
-	ath10k_dbg(ar, ATH10K_DBG_SNOC, "soc power on\n");
-
-	ret = regulator_bulk_enable(ar_snoc->num_vregs, ar_snoc->vregs);
-	if (ret)
-		return ret;
-
-	ret = clk_bulk_prepare_enable(ar_snoc->num_clks, ar_snoc->clks);
-	if (ret)
-		goto vreg_off;
-
-	return ret;
-
-vreg_off:
-	regulator_bulk_disable(ar_snoc->num_vregs, ar_snoc->vregs);
-	return ret;
-}
-
-static int ath10k_hw_power_off(struct ath10k *ar)
-{
-	struct ath10k_snoc *ar_snoc = ath10k_snoc_priv(ar);
-
-	ath10k_dbg(ar, ATH10K_DBG_SNOC, "soc power off\n");
-
-	clk_bulk_disable_unprepare(ar_snoc->num_clks, ar_snoc->clks);
-
-	return regulator_bulk_disable(ar_snoc->num_vregs, ar_snoc->vregs);
-}
-
 static void ath10k_msa_dump_memory(struct ath10k *ar,
 				   struct ath10k_fw_crash_data *crash_data)
 {
@@ -1712,22 +1722,16 @@ static int ath10k_snoc_probe(struct platform_device *pdev)
 	if (ret)
 		goto err_free_irq;
 
-	ret = ath10k_hw_power_on(ar);
-	if (ret) {
-		ath10k_err(ar, "failed to power on device: %d\n", ret);
-		goto err_free_irq;
-	}
-
 	ret = ath10k_setup_msa_resources(ar, msa_size);
 	if (ret) {
 		ath10k_warn(ar, "failed to setup msa resources: %d\n", ret);
-		goto err_power_off;
+		goto err_free_irq;
 	}
 
 	ret = ath10k_fw_init(ar);
 	if (ret) {
 		ath10k_err(ar, "failed to initialize firmware: %d\n", ret);
-		goto err_power_off;
+		goto err_free_irq;
 	}
 
 	ret = ath10k_qmi_init(ar, msa_size);
@@ -1743,9 +1747,6 @@ static int ath10k_snoc_probe(struct platform_device *pdev)
 err_fw_deinit:
 	ath10k_fw_deinit(ar);
 
-err_power_off:
-	ath10k_hw_power_off(ar);
-
 err_free_irq:
 	ath10k_snoc_free_irq(ar);
 
@@ -1773,7 +1774,6 @@ static int ath10k_snoc_remove(struct platform_device *pdev)
 	set_bit(ATH10K_SNOC_FLAG_UNREGISTERING, &ar_snoc->flags);
 
 	ath10k_core_unregister(ar);
-	ath10k_hw_power_off(ar);
 	ath10k_fw_deinit(ar);
 	ath10k_snoc_free_irq(ar);
 	ath10k_snoc_release_resource(ar);
Signature · 7 lines
2.7.4


_______________________________________________
ath10k mailing list
[email protected]
http://lists.infradead.org/mailman/listinfo/ath10k
#1 lore raw
Quoted 4 lines · Rakesh Pillai

When the wlan is disabled, i.e when all the interfaces are deleted, voltage regulator votes are not removed. This leads to more power consumption even when wlan is disabled.

Quoted 8 lines

Move the adding/removing of voltage regulator votes as part of hif power on/off in SNOC targets, so that these voltage regulator votes are there only when wlan is enabled.

Tested-on: WCN3990 hw1.0 SNOC WLAN.HL.3.1-01040-QCAHLSWMTPLZ-1

Patch applied to ath-next branch of ath.git, thanks.

5f1aa93ffa1f ath10k: Remove voltage regulator votes during wifi disable

Signature · 3 lines
https://patchwork.kernel.org/project/linux-wireless/patch/[email protected]/

https://wireless.wiki.kernel.org/en/developers/documentation/submittingpatches
#2 lore raw
In reply to Rakesh Pillai
Quoted 4 lines · Rakesh Pillai

When the wlan is disabled, i.e when all the interfaces are deleted, voltage regulator votes are not removed. This leads to more power consumption even when wlan is disabled.

Quoted 8 lines

Move the adding/removing of voltage regulator votes as part of hif power on/off in SNOC targets, so that these voltage regulator votes are there only when wlan is enabled.

Tested-on: WCN3990 hw1.0 SNOC WLAN.HL.3.1-01040-QCAHLSWMTPLZ-1

Patch applied to ath-next branch of ath.git, thanks.

5f1aa93ffa1f ath10k: Remove voltage regulator votes during wifi disable

Signature · 9 lines
https://patchwork.kernel.org/project/linux-wireless/patch/[email protected]/

https://wireless.wiki.kernel.org/en/developers/documentation/submittingpatches


_______________________________________________
ath10k mailing list
[email protected]
http://lists.infradead.org/mailman/listinfo/ath10k