arm64: dts: ls1028a: fix FlexSPI clock
Subsystems (2)
PATCH RESEND v3 1/1 arm64: dts: ls1028a: fix FlexSPI clock
Now that we have a proper driver for the FlexSPI interface use it. This will fix SCK frequency switching on Layerscape SoCs.
This was tested on the Kontron sl28 board.
---
Hi Shawn,
this is the last remaining piece of my previous series [1]. Now with the actual clock driver in v5.11 and the clockgen constants patches in your for-next branch, there are no further dependencies.
[1] https://lore.kernel.org/lkml/[email protected]/
Changlog from the old series:
Changes since v2:
- use device tree constants for clockgen
- also use &fspi_clk for fspi_en clock
Changes since v1:
- none
arch/arm64/boot/dts/freescale/fsl-ls1028a.dtsi | 16 +++++++++++++--- 1 file changed, 13 insertions(+), 3 deletions(-)
arch/arm64/boot/dts/freescale/fsl-ls1028a.dtsi +13 -3
@@ -206,9 +206,20 @@ }; dcfg: syscon@1e00000 { - compatible = "fsl,ls1028a-dcfg", "syscon"; + #address-cells = <1>; + #size-cells = <1>; + compatible = "fsl,ls1028a-dcfg", "syscon", "simple-mfd"; reg = <0x0 0x1e00000 0x0 0x10000>; + ranges = <0x0 0x0 0x1e00000 0x10000>; little-endian; + + fspi_clk: clock-controller@900 { + compatible = "fsl,ls1028a-flexspi-clk"; + reg = <0x900 0x4>; + #clock-cells = <0>; + clocks = <&clockgen QORIQ_CLK_HWACCEL 0>; + clock-output-names = "fspi_clk"; + }; }; rst: syscon@1e60000 {
@@ -326,8 +337,7 @@ <0x0 0x20000000 0x0 0x10000000>; reg-names = "fspi_base", "fspi_mmap"; interrupts = <GIC_SPI 25 IRQ_TYPE_LEVEL_HIGH>; - clocks = <&clockgen QORIQ_CLK_HWACCEL 0>, - <&clockgen QORIQ_CLK_HWACCEL 0>; + clocks = <&fspi_clk>, <&fspi_clk>; clock-names = "fspi_en", "fspi"; status = "disabled"; };
Signature · 1 line
2.20.1
Shawn Guo
AppliedQuoted 6 lines · Michael Walle
Now that we have a proper driver for the FlexSPI interface use it. This will fix SCK frequency switching on Layerscape SoCs.
This was tested on the Kontron sl28 board.
Signed-off-by Michael Walle <[email protected]>
Applied, thanks.