arm64: dts: imx8mq-kontron-pitx-imx8m: pass phy reset delays
Subsystems (2)
PATCH v2 1/1 arm64: dts: imx8mq-kontron-pitx-imx8m: pass phy reset delays
The TI DP83867 PHY datasheet says:
T1: Post RESET stabilization time == 195us
T3: Hardware configuration pins transition to output drivers == 64us
T4: RESET pulse width == 1us
So with a little overhead set 'reset-assert-us' to 10us (T4) and 'reset-deassert-us' to 280us (T1+T3).
Without these reset delays the board will hang during startup when bootargs has ip=dhcp set.
---
v2:
- add desciption what issue will be fixed
- add Fixes tag
arch/arm64/boot/dts/freescale/imx8mq-kontron-pitx-imx8m.dts | 2 ++ 1 file changed, 2 insertions(+)
arch/arm64/boot/dts/freescale/imx8mq-kontron-pitx-imx8m.dts +2 -0
@@ -90,6 +90,8 @@ ethphy0: ethernet-phy@0 { ti,tx-internal-delay = <DP83867_RGMIIDCTL_2_75_NS>; ti,fifo-depth = <DP83867_PHYCR_FIFO_DEPTH_4_B_NIB>; reset-gpios = <&gpio1 11 GPIO_ACTIVE_LOW>; + reset-assert-us = <10>; + reset-deassert-us = <280>; }; }; };
Signature · 1 line
2.30.0
Quoted 11 lines · Heiko Thiery
The TI DP83867 PHY datasheet says:
T1: Post RESET stabilization time == 195us
T3: Hardware configuration pins transition to output drivers == 64us
T4: RESET pulse width == 1usSo with a little overhead set 'reset-assert-us' to 10us (T4) and 'reset-deassert-us' to 280us (T1+T3).
Without these reset delays the board will hang during startup when bootargs has ip=dhcp set.
Quoted 6 lines
Fixes 1dc7f3d79a1a ("arm64: dts: fsl: add support for Kontron pitx-imx8m board")Signed-off-by Heiko Thiery <[email protected]>---
v2:
- add desciption what issue will be fixed
- add Fixes tag
My branch is not a stable one, so I just squashed it into the original commit.
Shawn