kconfig: streamline_config.pl: Couple of typo fixes
PATCH 1/1 kconfig: streamline_config.pl: Couple of typo fixes
s/configuraton/configuration/
s/orignal/original/
Signed-off-by Bhaskar Chowdhury <[email protected]>
--- scripts/kconfig/streamline_config.pl | 4 ++-- 1 file changed, 2 insertions(+), 2 deletions(-)
scripts/kconfig/streamline_config.pl +2 -2
@@ -21,7 +21,7 @@ # 1. Boot up the kernel that you want to stream line the config on. # 2. Change directory to the directory holding the source of the # kernel that you just booted. -# 3. Copy the configuraton file to this directory as .config +# 3. Copy the configuration file to this directory as .config # 4. Have all your devices that you need modules for connected and # operational (make sure that their corresponding modules are loaded) # 5. Run this script redirecting the output to some other file
@@ -481,7 +481,7 @@ sub parse_config_depends # The idea is we look at all the configs that select it. If one # is already in our list of configs to enable, then there's nothing # else to do. If there isn't, we pick the first config that was -# enabled in the orignal config and use that. +# enabled in the original config and use that. sub parse_config_selects { my ($config, $p) = @_;
--
2.26.2
Quoted 6 lines · Bhaskar Chowdhury
s/configuraton/configuration/
s/orignal/original/Signed-off-by Bhaskar Chowdhury <[email protected]>
Applied to linux-kbuild. Thanks.
Quoted 29 lines
--- scripts/kconfig/streamline_config.pl | 4 ++-- 1 file changed, 2 insertions(+), 2 deletions(-)scripts/kconfig/streamline_config.pl +2
-3@@ -21,7 +21,7 @@ # 1. Boot up the kernel that you want to stream line the config on. # 2. Change directory to the directory holding the source of the # kernel that you just booted. -# 3. Copy the configuraton file to this directory as .config +# 3. Copy the configuration file to this directory as .config # 4. Have all your devices that you need modules for connected and # operational (make sure that their corresponding modules are loaded) # 5. Run this script redirecting the output to some other file@@ -481,7 +481,7 @@ sub parse_config_depends # The idea is we look at all the configs that select it. If one # is already in our list of configs to enable, then there's nothing # else to do. If there isn't, we pick the first config that was -# enabled in the orignal config and use that. +# enabled in the original config and use that. sub parse_config_selects { my ($config, $p) = @_; --2.26.2
Signature · 2 lines
Best Regards Masahiro Yamada