dt-bindings: usb: usb-nop-xceiv: Convert to DT schema

deleted file mode 100644
index 4dc6a8ee3071..000000000000
@@ -1,43 +0,0 @@
-USB NOP PHY
-
-Required properties:
-- compatible: should be usb-nop-xceiv
-- #phy-cells: Must be 0
-
-Optional properties:
-- clocks: phandle to the PHY clock. Use as per Documentation/devicetree
-  /bindings/clock/clock-bindings.txt
-  This property is required if clock-frequency is specified.
-
-- clock-names: Should be "main_clk"
-
-- clock-frequency: the clock frequency (in Hz) that the PHY clock must
-  be configured to.
-
-- vcc-supply: phandle to the regulator that provides power to the PHY.
-
-- reset-gpios: Should specify the GPIO for reset.
-
-- vbus-detect-gpio: should specify the GPIO detecting a VBus insertion
-                    (see Documentation/devicetree/bindings/gpio/gpio.txt)
-- vbus-regulator : should specifiy the regulator supplying current drawn from
-  the VBus line (see Documentation/devicetree/bindings/regulator/regulator.txt).
-
-Example:
-
-	hsusb1_phy {
-		compatible = "usb-nop-xceiv";
-		clock-frequency = <19200000>;
-		clocks = <&osc 0>;
-		clock-names = "main_clk";
-		vcc-supply = <&hsusb1_vcc_regulator>;
-		reset-gpios = <&gpio1 7 GPIO_ACTIVE_LOW>;
-		vbus-detect-gpio = <&gpio2 13 GPIO_ACTIVE_HIGH>;
-		vbus-regulator = <&vbus_regulator>;
-		#phy-cells = <0>;
-	};
-
-hsusb1_phy is a NOP USB PHY device that gets its clock from an oscillator
-and expects that clock to be configured to 19.2MHz by the NOP PHY driver.
-hsusb1_vcc_regulator provides power to the PHY and GPIO 7 controls RESET.
-GPIO 13 detects VBus insertion, and accordingly notifies the vbus-regulator.

64 lines not on this page · raw message