Tegra ARM64 device-tree improvements for 5.15
Subsystems (2)
cover Tegra ARM64 device-tree improvements for 5.15
A single patch here that doesn't fit into the ARM32 series of improvements, but fixes the same problem that affects the ARM32 boards too.
Dmitry Osipenko (1):
arm64: tegra194: p2888: Correct interrupt trigger type of temperature
sensor
arch/arm64/boot/dts/nvidia/tegra194-p2888.dtsi | 2 +- 1 file changed, 1 insertion(+), 1 deletion(-)
Signature · 1 line
2.32.0
PATCH 1/1 arm64: tegra194: p2888: Correct interrupt trigger type of temperature sensor
The LM90 temperature sensor should use edge-triggered interrupt because LM90 hardware doesn't deassert interrupt line until temperature is back to normal state, which results in interrupt storm. Correct the interrupt trigger type.
--- arch/arm64/boot/dts/nvidia/tegra194-p2888.dtsi | 2 +- 1 file changed, 1 insertion(+), 1 deletion(-)
arch/arm64/boot/dts/nvidia/tegra194-p2888.dtsi +1 -1
@@ -309,7 +309,7 @@ temperature-sensor@4c { interrupt-parent = <&gpio>; interrupts = <TEGRA194_MAIN_GPIO(H, 2) - IRQ_TYPE_LEVEL_LOW>; + IRQ_TYPE_EDGE_FALLING>; vcc-supply = <&vdd_1v8ls>; #thermal-sensor-cells = <1>;
Signature · 1 line
2.32.0
Thierry Reding
AppliedRe: [PATCH v1 1/1] arm64: tegra194: p2888: Correct interrupt trigger type of temperature sensor
Quoted 9 lines · Dmitry Osipenko
The LM90 temperature sensor should use edge-triggered interrupt because LM90 hardware doesn't deassert interrupt line until temperature is back to normal state, which results in interrupt storm. Correct the interrupt trigger type.
Signed-off-by Dmitry Osipenko <[email protected]>--- arch/arm64/boot/dts/nvidia/tegra194-p2888.dtsi | 2 +- 1 file changed, 1 insertion(+), 1 deletion(-)
Applied, thanks.
Thierry