Skip to contentSkip to conversation

xhci fix for usb-linus

PATCH New Mathias Nyman 1 participant 2 messages Jul 15, 2021

Subsystems (3)
lore
Share & tools
lore
#0 lore raw

cover xhci fix for usb-linus

Hi Greg

One small xhci fix resolving a missed usb 2 device-intiated wake.

I'll be out on vacation for two weeks, starting monday, so any response will be delayed.

Thanks
-Mathias

Mathias Nyman (1):
xhci: Fix lost USB 2 remote wake

 drivers/usb/host/xhci-hub.c | 3 ++-
 1 file changed, 2 insertions(+), 1 deletion(-)
Signature · 1 line
2.25.1
#1 lore raw

PATCH 1/1 xhci: Fix lost USB 2 remote wake

There's a small window where a USB 2 remote wake may be left unhandled due to a race between hub thread and xhci port event interrupt handler.

When the resume event is detected in the xhci interrupt handler it kicks the hub timer, which should move the port from resume to U0 once resume has been signalled for long enough.

To keep the hub "thread" running we set a bus_state->resuming_ports flag. This flag makes sure hub timer function kicks itself.

checking this flag was not properly protected by the spinlock. Flag was copied to a local variable before lock was taken. The local variable was then checked later with spinlock held.

If interrupt is handled right after copying the flag to the local variable we end up stopping the hub thread before it can handle the USB 2 resume.

CPU0 CPU1
(hub thread) (xhci event handler)

xhci_hub_status_data()

status = bus_state->resuming_ports;
					<Interrupt>
					handle_port_status()
					spin_lock()
					bus_state->resuming_ports = 1
					set_flag(HCD_FLAG_POLL_RH)
					spin_unlock()

spin_lock()
if (!status)
clear_flag(HCD_FLAG_POLL_RH)
spin_unlock()

Fix this by taking the lock a bit earlier so that it covers the resuming_ports flag copy in the hub thread

---
 drivers/usb/host/xhci-hub.c | 3 ++-
 1 file changed, 2 insertions(+), 1 deletion(-)
drivers/usb/host/xhci-hub.c +2 -1
index e9b18fc17617..151e93c4bd57 100644
@@ -1638,11 +1638,12 @@ int xhci_hub_status_data(struct usb_hcd *hcd, char *buf)
 	 * Inform the usbcore about resume-in-progress by returning
 	 * a non-zero value even if there are no status changes.
 	 */
+	spin_lock_irqsave(&xhci->lock, flags);
+
 	status = bus_state->resuming_ports;
 
 	mask = PORT_CSC | PORT_PEC | PORT_OCC | PORT_PLC | PORT_WRC | PORT_CEC;
 
-	spin_lock_irqsave(&xhci->lock, flags);
 	/* For each port, did anything change?  If so, set that bit in buf. */
 	for (i = 0; i < max_ports; i++) {
 		temp = readl(ports[i]->addr);
Signature · 1 line
2.25.1