package/usbguard: enforce the right permissions on the configuration file
PATCH 1/1 package/usbguard: enforce the right permissions on the configuration file
Only 0600 rights are allowed for the rules.conf. This file is read when the usbguard daemon starts and will prevent it to run otherwise.
As Git only tracks the executable bit, setting the right permissions in the package makefile is the cleanest solution, in particular when providing this file from a rootfs overlay.
--- package/usbguard/usbguard.mk | 3 +++ 1 file changed, 3 insertions(+)
package/usbguard/usbguard.mk +3 -0
@@ -47,5 +47,8 @@ define USBGUARD_INSTALL_INIT_SYSV $(TARGET_DIR)/etc/init.d/S20usbguard endef +define USBGUARD_PERMISSIONS + /etc/usbguard/rules.conf f 0600 0 0 - - - - - +endef $(eval $(autotools-package))
Signature · 1 line
2.27.0
Thomas Petazzoni
AppliedPATCH 1/1 package/usbguard: enforce the right permissions on the configuration file
Quoted 11 lines · On Fri, 18 Jun 2021 11:47:10 +0200 Miquel Raynal <[email protected]>…
Only 0600 rights are allowed for the rules.conf. This file is read when the usbguard daemon starts and will prevent it to run otherwise.
As Git only tracks the executable bit, setting the right permissions in the package makefile is the cleanest solution, in particular when providing this file from a rootfs overlay.
Signed-off-by Miquel Raynal <[email protected]>--- package/usbguard/usbguard.mk | 3 +++ 1 file changed, 3 insertions(+)
Applied to master, thanks.
Thomas
Signature · 3 lines
Thomas Petazzoni, CTO, Bootlin Embedded Linux and Kernel engineering https://bootlin.com