Skip to contentSkip to conversation

i2c-tools 4.3 has been released

DISCUSSION Jean Delvare 1 participant 2 messages Jul 22, 2021 – Jul 27, 2021 I2C subsystem host drivers

lore
Share & tools
lore
#0 lore raw

Hi all,

A new version of i2c-tools was tagged and released today. You can download i2c-tools 4.3 at the usual place:
https://www.kernel.org/pub/software/utils/i2c-tools/

It includes almost one year worth of fixes and improvements. Changes are as follows:
* decode-dimms: Attempt to decode LPDDR3 modules
* eeprom, eepromer: Removed the tools in favor of eeprog
* i2cdetect: Sort the bus list by number
* i2cdump: Add range support to I2C block mode Deprecate SMBus block mode
* i2cget: Add support for I2C block read
Add support for SMBus block read
* i2ctransfer: Reverted check for returned length from driver

Signature · 2 lines
Jean Delvare
SUSE L3 Support
#1 lore raw
Quoted 4 lines · Jean Delvare

A new version of i2c-tools was tagged and released today. You can download i2c-tools 4.3 at the usual place:
https://www.kernel.org/pub/software/utils/i2c-tools/

Quoted 10 lines

It includes almost one year worth of fixes and improvements. Changes are as follows:
* decode-dimms: Attempt to decode LPDDR3 modules
* eeprom, eepromer: Removed the tools in favor of eeprog
* i2cdetect: Sort the bus list by number
* i2cdump: Add range support to I2C block mode Deprecate SMBus block mode
* i2cget: Add support for I2C block read
Add support for SMBus block read
* i2ctransfer: Reverted check for returned length from driver

Unfortunately I made a packaging mistake when preparing the tarballs. The prefix inside the archive was accidentally set to i2c-tools-4.0 instead of i2c-tools-4.3. As this is quite confusing and inconvenient for distribution packagers, I have just regenerated and pushed a clean tarball with the proper prefix. Just give it some time to reach the mirrors.

Signature · 2 lines
Jean Delvare
SUSE L3 Support