mx28evk: Only keep the main target
PATCH 1/1 mx28evk: Only keep the main target
mx28evk_auart_console_defconfig, mx28evk_nand_defconfig and mx28evk_spi_defconfig have not been converted to DM.
Keep only the main mx28evk_defconfig to ease maintenance.
Signed-off-by Fabio Estevam <[email protected]>
--- board/freescale/mx28evk/MAINTAINERS | 3 -- board/freescale/mx28evk/README | 34 +--------------- configs/mx28evk_auart_console_defconfig | 52 ------------------------ configs/mx28evk_nand_defconfig | 53 ------------------------- configs/mx28evk_spi_defconfig | 49 ----------------------- 5 files changed, 2 insertions(+), 189 deletions(-) delete mode 100644 configs/mx28evk_auart_console_defconfig delete mode 100644 configs/mx28evk_nand_defconfig delete mode 100644 configs/mx28evk_spi_defconfig
board/freescale/mx28evk/MAINTAINERS +0 -3
@@ -5,6 +5,3 @@ F: board/freescale/mx28evk/ F: arch/arm/dts/imx28-evk.dts F: include/configs/mx28evk.h F: configs/mx28evk_defconfig -F: configs/mx28evk_auart_console_defconfig -F: configs/mx28evk_nand_defconfig -F: configs/mx28evk_spi_defconfig
board/freescale/mx28evk/README +2 -32
@@ -23,40 +23,10 @@ To boot MX28EVK from an SD card, set the boot mode DIP switches as: * VDD 5V: To the left (off) * Hold Button: Down (off) -To boot MX28EVK from SPI NOR flash, set the boot mode DIP switches as: - - * Boot Mode Select: 0 0 1 0 (Boot from SSP2) - * JTAG PSWITCH RESET: To the right (reset disabled) - * Battery Source: Down - * Wall 5V: Up - * VDD 5V: To the left (off) - * Hold Button: Down (off) - Environment Storage ------------------- -There are three targets for mx28evk: - -"make mx28evk_config" - store environment variables into MMC - -or - -"make mx28evk_nand_config" - store environment variables into NAND flash - -or - -"make mx28evk_spi_config" - store environment variables into SPI NOR flash - -Choose the target accordingly. - -Note: The mx28evk board does not come with a NAND flash populated from the -factory. It comes with an empty slot (U23), which allows the insertion of a -48-pin TSOP flash device. - -mx28evk does not come with SPI NOR flash populated from the factory either. -It is possible to solder a SOIC memory on U49 or use a DIP8 on J89. -To get SPI communication to work R320, R321,R322 and C178 need to be populated. -Look in the schematics for the proper component values. +"make mx28evk_defconfig" - store environment variables into MMC Follow the instructions from doc/imx/common/mxs.txt to generate a bootable -SD card or to generate a binary to be flashed into SPI NOR. +SD card.
configs/mx28evk_auart_console_defconfig deleted +0 -52
52 lines not on this page · raw message
configs/mx28evk_nand_defconfig deleted +0 -53
53 lines not on this page · raw message
configs/mx28evk_spi_defconfig deleted +0 -49
49 lines not on this page · raw message
Signature · 1 line
2.25.1