ARM: dts: am335x-pocketbeagle: switch to pinconf-single
PATCH 1/1 ARM: dts: am335x-pocketbeagle: switch to pinconf-single
Switch the compatible for the am33xx_pinmux pin controller node from pinctrl-single to pinconf-single. The only change between these two compatibles is that PCS_HAS_PINCONF will be true. This then allows pinconf properties to be utilized.
The purpose of this change is to allow the PocketBeagle to use:
pinctrl-single,bias-pullup
pinctrl-single,bias-pulldown
This dts already defines these properites for gpio pins in the default pinctrl state but it has no effect unless PCS_HAS_PINCONF is set.
The bias properties can then be modified on the corresponding gpio lines through the gpiod uapi. The mapping between the pins and gpio lines is defined by gpio-ranges under the gpio controller nodes in am33xx-l4.dtsi
--- arch/arm/boot/dts/am335x-pocketbeagle.dts | 1 + 1 file changed, 1 insertion(+)
arch/arm/boot/dts/am335x-pocketbeagle.dts +1 -0
@@ -205,6 +205,7 @@ &gpio3 { &am33xx_pinmux { + compatible = "pinconf-single"; pinctrl-names = "default"; pinctrl-0 = < &P2_03_gpio &P1_34_gpio &P2_19_gpio &P2_24_gpio
Signature · 1 line
2.27.0
Quoted 10 lines · Drew Fustini
Switch the compatible for the
am33xx_pinmuxpin controller node from pinctrl-single to pinconf-single. The only change between these two compatibles is thatPCS_HAS_PINCONFwill be true. This then allows pinconf properties to be utilized.The purpose of this change is to allow the PocketBeagle to use:
pinctrl-single,bias-pullup
pinctrl-single,bias-pulldown
Quoted 6 lines
This dts already defines these properites for gpio pins in the default pinctrl state but it has no effect unless
PCS_HAS_PINCONFis set.The bias properties can then be modified on the corresponding gpio lines through the gpiod uapi. The mapping between the pins and gpio lines is defined by gpio-ranges under the gpio controller nodes in
am33xx-l4.dtsi
Thanks applying into omap-for-v5.16/dt.
Tony