Kconfig: Use spaces not tabs in Kconfig entires
Subsystems (3)
PATCH 1/1 Kconfig: Use spaces not tabs in Kconfig entires
While the Kconfig language seems to accept either form of whitespace, we use a space throughout the project, except in these spots.
Signed-off-by Tom Rini <[email protected]>
--- arch/arm/mach-exynos/Kconfig | 2 +- board/freescale/mx6memcal/Kconfig | 4 ++-- 2 files changed, 3 insertions(+), 3 deletions(-)
arch/arm/mach-exynos/Kconfig +1 -1
@@ -141,7 +141,7 @@ if ARCH_EXYNOS7 choice prompt "EXYNOS7 board select" -config TARGET_ESPRESSO7420 +config TARGET_ESPRESSO7420 bool "ESPRESSO7420 board" select ARM64 select ARMV8_MULTIENTRY
board/freescale/mx6memcal/Kconfig +2 -2
@@ -87,12 +87,12 @@ choice help Select the type of DDR (DDR3 or LPDDR2) used on your design -config DDR3 +config DDR3 bool "DDR3" help Select this if your board design uses DDR3. -config LPDDR2 +config LPDDR2 bool "LPDDR2" help Select this if your board design uses LPDDR2.
Signature · 1 line
2.17.1
Quoted 4 lines · Tom Rini
While the
Kconfiglanguage seems to accept either form of whitespace, we use a space throughout the project, except in these spots.Signed-off-by Tom Rini <[email protected]>
Applied to u-boot/next, thanks!
Signature · 1 line
Tom