ARM: dts: imx6qdl-pico: Fix Ethernet support

Currently, it is no longer possible to retrieve a DHCP address on the imx6qdl-pico board.

This issue has been exposed by commit f5d9aa79dfdf ("ARM: imx6q:
remove clk-out fixup for the Atheros AR8031 and AR8035 PHYs").

Fix it by describing the qca,clk-out-frequency property as suggested by the commit above.

---
Changes since v2:
- Do not move the reset properties (Russell).

 arch/arm/boot/dts/imx6qdl-pico.dtsi | 10 ++++++++++
 1 file changed, 10 insertions(+)

index 5de4ccb97916..fe8a93fc65b8 100644
@@ -177,6 +177,16 @@ &fec {
 	phy-mode = "rgmii-id";
 	phy-reset-gpios = <&gpio1 26 GPIO_ACTIVE_LOW>;
 	status = "okay";
+
+	mdio {
+		#address-cells = <1>;
+		#size-cells = <0>;
+
+		phy: ethernet-phy@1 {
+			reg = <1>;
+			qca,clk-out-frequency = <125000000>;
+		};
+	};
 };
 
 &hdmi {

2.25.1


_______________________________________________
linux-arm-kernel mailing list
[email protected]
http://lists.infradead.org/mailman/listinfo/linux-arm-kernel

Now that you have the PHY listed in DT, you could use a phy-handle to point to it.

Andrew

_______________________________________________
linux-arm-kernel mailing list
[email protected]
http://lists.infradead.org/mailman/listinfo/linux-arm-kernel