Kernel 5.10 - imx-media does not create /dev/media0
Hi list,
(long time no see!)
I switched from a Freescale kernel 5.4 to a vanilla 5.10 on IMX6Solo board. The device is using a ADV7280 as analog-video-ADC.
I tried to apply the good options to my kernel-config, but I'm unable to get the media-controller device appear. I see
[ 757.594463] irq: type mismatch, failed to map hwirq-21 for gpio@20a8000! [ 757.655328] adv7180 2-0021: chip found @ 0x21 (21a8000.i2c)
that the adv7280 is found and attached, as well as the ipu and it's video-devices.
[ 11.069123] videodev: Linux video capture interface: v2.00 [ 12.553347] ipu1_csi0: Registered ipu1_csi0 capture as /dev/video0 [ 12.681897] ipu1_ic_prpenc: Registered ipu1_ic_prpenc capture as /dev/video1 [ 12.785205] ipu1_ic_prpvf: Registered ipu1_ic_prpvf capture as /dev/video2 [ 12.914702] ipu1_csi1: Registered ipu1_csi1 capture as /dev/video3
I'm using the same device-tree as I used with fscl-5.4.
Before writing an even longer email pasting everything I did I'd like to know which information is actually useful to debug this?
I'm hoping there is something obvious which I missed?
I'm wondering whether I shoud v4l-subdev to be created, which I don't in dmesg.
Thanks in advance for any help,
--
Patrick.
Quoted 17 lines · On Wed, 27 Oct 2021 23:04:12 +0000 Patrick Boettcher…
Hi list,
(long time no see!)
I switched from a Freescale kernel 5.4 to a vanilla 5.10 on IMX6Solo board. The device is using a ADV7280 as analog-video-ADC.
I tried to apply the good options to my kernel-config, but I'm unable to get the media-controller device appear. I see
[ 757.594463] irq: type mismatch, failed to map hwirq-21 forgpio@20a8000! [ 757.655328] adv7180 2-0021: chip found @
0x21(21a8000.i2c)that the adv7280 is found and attached, as well as the ipu and it's video-devices.
Quoted 6 lines
[ 11.069123] videodev: Linux video capture interface: v2.00 [ 12.553347] ipu1_csi0: Registered ipu1_csi0 capture as /dev/video0 [ 12.681897] ipu1_ic_prpenc: Registered ipu1_ic_prpenc capture as
/dev/video1[ 12.785205]ipu1_ic_prpvf: Registeredipu1_ic_prpvf
capture as/dev/video2[ 12.914702]ipu1_csi1: Registeredipu1_csi1
capture as/dev/video3
Here's a list of all modules which got loaded:
adv7180 20480 0 snd_soc_sgtl5000 28672 0 pfuze100_regulator 28672 0 regmap_i2c 16384 2 imx6_media_csi 28672 2 snd_soc_imx_sgtl5000 16384 fec 53248 0 snd_soc_fsl_asoc_card 24576 v4l2_fwnode 24576 1 ptp 28672 1 pps_core 20480 1 of_mdio 16384 2 snd_soc_imx_audmux 16384 2 fixed_phy 16384 1 i2c_imx 20480 0 libphy 126976 4 imx6_media 49152 0 video_mux 16384 0 mux_core 16384 1 imx_media_common 40960 2 videobuf2_dma_contig 16384 v4l2_mem2mem 36864 1 videobuf2_memops 16384 1 videobuf2_v4l2 32768 3 snd_soc_fsl_asrc 24576 0 videobuf2_common 57344 5 snd_soc_fsl_ssi 24576 0 imx_pcm_dma 16384 1 videodev 233472 9 i2c_core 69632 8
Maybe it'll help to spot the problem immediately.
--
Patrick.
Quoted 4 lines · On Thu, 28 Oct 2021 06:58:47 +0000 Patrick Boettcher…
On Wed, 27 Oct 2021 23:04:12 +0000
Patrick Boettcher <[email protected]> wrote:Maybe it'll help to spot the problem immediately.
I was missing CONFIG_MUX_MMIO. Strange that it's not activated by default.
Should it?
--
Patrick.