Skip to contentSkip to conversation

spi: cadence-quadspi: fix write completion support

PATCH In review Dinh Nguyen 3 participants 3 messages Nov 8, 2021 – Nov 12, 2021 SPI

lore
Share & tools
lore
#0 lore raw

PATCH 1/1 spi: cadence-quadspi: fix write completion support

Some versions of the Cadence QSPI controller does not have the write completion register implemented(CQSPI_REG_WR_COMPLETION_CTRL). On the Intel SoCFPGA platform the CQSPI_REG_WR_COMPLETION_CTRL register is not configured.

Add a quirk to not write to the CQSPI_REG_WR_COMPLETION_CTRL register.

Fixes 9cb2ff111712 ("spi: cadence-quadspi: Disable Auto-HW polling)
---
 drivers/spi/spi-cadence-quadspi.c | 24 +++++++++++++++++++++---
 1 file changed, 21 insertions(+), 3 deletions(-)
drivers/spi/spi-cadence-quadspi.c +21 -3
index 8b3d268ac63c..b808c94641fa 100644
@@ -37,6 +37,7 @@
 #define CQSPI_NEEDS_WR_DELAY		BIT(0)
 #define CQSPI_DISABLE_DAC_MODE		BIT(1)
 #define CQSPI_SUPPORT_EXTERNAL_DMA	BIT(2)
+#define CQSPI_NO_SUPPORT_WR_COMPLETION	BIT(3)
 
 /* Capabilities */
 #define CQSPI_SUPPORTS_OCTAL		BIT(0)
@@ -86,6 +87,7 @@ struct cqspi_st {
 	struct cqspi_flash_pdata f_pdata[CQSPI_MAX_CHIPSELECT];
 	bool			use_dma_read;
 	u32			pd_dev_id;
+	bool			wr_completion;
 };
 
 struct cqspi_driver_platdata {
@@ -996,9 +998,11 @@ static int cqspi_write_setup(struct cqspi_flash_pdata *f_pdata,
 	 * polling on the controller's side. spinand and spi-nor will take
 	 * care of polling the status register.
 	 */
-	reg = readl(reg_base + CQSPI_REG_WR_COMPLETION_CTRL);
-	reg |= CQSPI_REG_WR_DISABLE_AUTO_POLL;
-	writel(reg, reg_base + CQSPI_REG_WR_COMPLETION_CTRL);
+	if (cqspi->wr_completion) {
+		reg = readl(reg_base + CQSPI_REG_WR_COMPLETION_CTRL);
+		reg |= CQSPI_REG_WR_DISABLE_AUTO_POLL;
+		writel(reg, reg_base + CQSPI_REG_WR_COMPLETION_CTRL);
+	}
 
 	reg = readl(reg_base + CQSPI_REG_SIZE);
 	reg &= ~CQSPI_REG_SIZE_ADDRESS_MASK;
@@ -1736,6 +1740,10 @@ static int cqspi_probe(struct platform_device *pdev)
 
 	cqspi->master_ref_clk_hz = clk_get_rate(cqspi->clk);
 	master->max_speed_hz = cqspi->master_ref_clk_hz;
+
+	/* write completion is supported by default */
+	cqspi->wr_completion = true;
+
 	ddata  = of_device_get_match_data(dev);
 	if (ddata) {
 		if (ddata->quirks & CQSPI_NEEDS_WR_DELAY)
@@ -1747,6 +1755,8 @@ static int cqspi_probe(struct platform_device *pdev)
 			cqspi->use_direct_mode = true;
 		if (ddata->quirks & CQSPI_SUPPORT_EXTERNAL_DMA)
 			cqspi->use_dma_read = true;
+		if (ddata->quirks & CQSPI_NO_SUPPORT_WR_COMPLETION)
+			cqspi->wr_completion = false;
 
 		if (of_device_is_compatible(pdev->dev.of_node,
 					    "xlnx,versal-ospi-1.0"))
@@ -1859,6 +1869,10 @@ static const struct cqspi_driver_platdata intel_lgm_qspi = {
 	.quirks = CQSPI_DISABLE_DAC_MODE,
 };
 
+static const struct cqspi_driver_platdata socfpga_qspi = {
+	.quirks = CQSPI_NO_SUPPORT_WR_COMPLETION,
+};
+
 static const struct cqspi_driver_platdata versal_ospi = {
 	.hwcaps_mask = CQSPI_SUPPORTS_OCTAL,
 	.quirks = CQSPI_DISABLE_DAC_MODE | CQSPI_SUPPORT_EXTERNAL_DMA,
@@ -1887,6 +1901,10 @@ static const struct of_device_id cqspi_dt_ids[] = {
 		.compatible = "xlnx,versal-ospi-1.0",
 		.data = (void *)&versal_ospi,
 	},
+	{
+		.compatible = "intel,socfpga-qspi",
+		.data = (void *)&socfpga_qspi,
+	},
 	{ /* end of table */ }
 };
 
Signature · 1 line
2.25.1
Reviewed-by on v1 1/1
#1 lore raw
Quoted 26 lines · Dinh Nguyen

Some versions of the Cadence QSPI controller does not have the write completion register implemented(CQSPI_REG_WR_COMPLETION_CTRL). On the Intel SoCFPGA platform the CQSPI_REG_WR_COMPLETION_CTRL register is not configured.

Add a quirk to not write to the CQSPI_REG_WR_COMPLETION_CTRL register.

Fixes 9cb2ff111712 ("spi: cadence-quadspi: Disable Auto-HW polling)
---
 drivers/spi/spi-cadence-quadspi.c | 24 +++++++++++++++++++++---
 1 file changed, 21 insertions(+), 3 deletions(-)
drivers/spi/spi-cadence-quadspi.c +1 -0
index 8b3d268ac63c..b808c94641fa 100644
@@ -37,6 +37,7 @@
 #define CQSPI_NEEDS_WR_DELAY		BIT(0)
 #define CQSPI_DISABLE_DAC_MODE		BIT(1)
 #define CQSPI_SUPPORT_EXTERNAL_DMA	BIT(2)
+#define CQSPI_NO_SUPPORT_WR_COMPLETION	BIT(3)
 
 /* Capabilities */
 #define CQSPI_SUPPORTS_OCTAL		BIT(0)

drivers/spi/spi-cadence-quadspi.c struct cqspi_st { · line 90

Quoted 4 lines
drivers/spi/spi-cadence-quadspi.c +1 -0
@@ -86,6 +87,7 @@ struct cqspi_st {
 	struct cqspi_flash_pdata f_pdata[CQSPI_MAX_CHIPSELECT];
 	bool			use_dma_read;
 	u32			pd_dev_id;
+	bool			wr_completion;

We have a bunch of bools lying around in this struct: is_decoded_cs, rclk_en, use_direct_mode, use_dma_read, and now wr_completion. It is probably worth it to use bitfields and save some memory.

Anyway, I don't consider this a blocker. So either way,

Quoted 63 lines
drivers/spi/spi-cadence-quadspi.c +19 -3
 };
 
 struct cqspi_driver_platdata {
@@ -996,9 +998,11 @@ static int cqspi_write_setup(struct cqspi_flash_pdata *f_pdata,
 	 * polling on the controller's side. spinand and spi-nor will take
 	 * care of polling the status register.
 	 */
-	reg = readl(reg_base + CQSPI_REG_WR_COMPLETION_CTRL);
-	reg |= CQSPI_REG_WR_DISABLE_AUTO_POLL;
-	writel(reg, reg_base + CQSPI_REG_WR_COMPLETION_CTRL);
+	if (cqspi->wr_completion) {
+		reg = readl(reg_base + CQSPI_REG_WR_COMPLETION_CTRL);
+		reg |= CQSPI_REG_WR_DISABLE_AUTO_POLL;
+		writel(reg, reg_base + CQSPI_REG_WR_COMPLETION_CTRL);
+	}
 
 	reg = readl(reg_base + CQSPI_REG_SIZE);
 	reg &= ~CQSPI_REG_SIZE_ADDRESS_MASK;
@@ -1736,6 +1740,10 @@ static int cqspi_probe(struct platform_device *pdev)
 
 	cqspi->master_ref_clk_hz = clk_get_rate(cqspi->clk);
 	master->max_speed_hz = cqspi->master_ref_clk_hz;
+
+	/* write completion is supported by default */
+	cqspi->wr_completion = true;
+
 	ddata  = of_device_get_match_data(dev);
 	if (ddata) {
 		if (ddata->quirks & CQSPI_NEEDS_WR_DELAY)
@@ -1747,6 +1755,8 @@ static int cqspi_probe(struct platform_device *pdev)
 			cqspi->use_direct_mode = true;
 		if (ddata->quirks & CQSPI_SUPPORT_EXTERNAL_DMA)
 			cqspi->use_dma_read = true;
+		if (ddata->quirks & CQSPI_NO_SUPPORT_WR_COMPLETION)
+			cqspi->wr_completion = false;
 
 		if (of_device_is_compatible(pdev->dev.of_node,
 					    "xlnx,versal-ospi-1.0"))
@@ -1859,6 +1869,10 @@ static const struct cqspi_driver_platdata intel_lgm_qspi = {
 	.quirks = CQSPI_DISABLE_DAC_MODE,
 };
 
+static const struct cqspi_driver_platdata socfpga_qspi = {
+	.quirks = CQSPI_NO_SUPPORT_WR_COMPLETION,
+};
+
 static const struct cqspi_driver_platdata versal_ospi = {
 	.hwcaps_mask = CQSPI_SUPPORTS_OCTAL,
 	.quirks = CQSPI_DISABLE_DAC_MODE | CQSPI_SUPPORT_EXTERNAL_DMA,
@@ -1887,6 +1901,10 @@ static const struct of_device_id cqspi_dt_ids[] = {
 		.compatible = "xlnx,versal-ospi-1.0",
 		.data = (void *)&versal_ospi,
 	},
+	{
+		.compatible = "intel,socfpga-qspi",
+		.data = (void *)&socfpga_qspi,
+	},
 	{ /* end of table */ }
 };
 
Signature · 1 line
2.25.1
Signature · 3 lines
Regards,
Pratyush Yadav
Texas Instruments Inc.
maintainer
#2 lore raw
In reply to Dinh Nguyen
Quoted 8 lines · Dinh Nguyen

Some versions of the Cadence QSPI controller does not have the write completion register implemented(CQSPI_REG_WR_COMPLETION_CTRL). On the Intel SoCFPGA platform the CQSPI_REG_WR_COMPLETION_CTRL register is not configured.

Add a quirk to not write to the CQSPI_REG_WR_COMPLETION_CTRL register.

[...]

Applied to

https://git.kernel.org/pub/scm/linux/kernel/git/broonie/spi.git for-linus

Thanks!

[1/1] spi: cadence-quadspi: fix write completion support

      commit: 98d948eb833104a094517401ed8be26ba3ce9935

All being well this means that it will be integrated into the linux-next tree (usually sometime in the next 24 hours) and sent to Linus during the next merge window (or sooner if it is a bug fix), however if problems are discovered then the patch may be dropped or reverted.

You may get further e-mails resulting from automated or manual testing and review of the tree, please engage with people reporting problems and send followup patches addressing any issues that are reported if needed.

If any updates are required or you are submitting further changes they should be sent as incremental updates against current git, existing patches will not be replaced.

Please add any relevant lists and maintainers to the CCs when replying to this mail.

Thanks,
Mark