Skip to contentSkip to conversation

mmc: sdhci-pci-gli: GL9755: Quirks for Apple ARM platforms

PATCH In review Hector Martin 2 participants 4 messages Dec 15, 2021 – Dec 21, 2021

Subsystems (2)
lore
Share & tools
lore
#0 lore raw

v3 cover mmc: sdhci-pci-gli: GL9755: Quirks for Apple ARM platforms

Hi folks,

This short series adds a few quirks needed to make the card readers in Apple M1 Pro/Max MacBook laptops work properly.

The first patch should be straightforward; it just allows configuring the CD/WP polarity based on device tree settings. There is already a standard DT binding for this.

The second patch works around an issue with 8/16-bit MMIO reads that only affects these platforms, for some reason.

Changes since v2:
- Style fixes

Hector Martin (2):
mmc: sdhci-pci-gli: GL9755: Support for CD/WP inversion on OF
platforms
mmc: sdhci-pci-gli: GL975[50]: Issue 8/16-bit MMIO reads as 32-bit
reads.

 drivers/mmc/host/sdhci-pci-gli.c | 34 ++++++++++++++++++++++++++++++++
 1 file changed, 34 insertions(+)
Signature · 1 line
2.33.0
#1 lore raw

PATCH v3 1/2 mmc: sdhci-pci-gli: GL9755: Support for CD/WP inversion on OF platforms

This is required on some Apple ARM64 laptops using this controller. As is typical on DT platforms, pull these quirks from the device tree using the standard mmc bindings.

See Documentation/devicetree/bindings/mmc/mmc-controller.yaml

---
 drivers/mmc/host/sdhci-pci-gli.c | 11 +++++++++++
 1 file changed, 11 insertions(+)
drivers/mmc/host/sdhci-pci-gli.c +11 -0
index 4fd99c1e82ba..ad50f16658fe 100644
@@ -12,6 +12,7 @@
 #include <linux/pci.h>
 #include <linux/mmc/mmc.h>
 #include <linux/delay.h>
+#include <linux/of.h>
 #include "sdhci.h"
 #include "sdhci-pci.h"
 #include "cqhci.h"
@@ -116,6 +117,8 @@
 #define PCI_GLI_9755_PECONF   0x44
 #define   PCI_GLI_9755_LFCLK    GENMASK(14, 12)
 #define   PCI_GLI_9755_DMACLK   BIT(29)
+#define   PCI_GLI_9755_INVERT_CD  BIT(30)
+#define   PCI_GLI_9755_INVERT_WP  BIT(31)
 
 #define PCI_GLI_9755_CFG2          0x48
 #define   PCI_GLI_9755_CFG2_L1DLY    GENMASK(28, 24)
@@ -570,6 +573,14 @@ static void gl9755_hw_setting(struct sdhci_pci_slot *slot)
 	gl9755_wt_on(pdev);
 
 	pci_read_config_dword(pdev, PCI_GLI_9755_PECONF, &value);
+	/*
+	 * Apple ARM64 platforms using these chips may have
+	 * inverted CD/WP detection.
+	 */
+	if (of_property_read_bool(pdev->dev.of_node, "cd-inverted"))
+		value |= PCI_GLI_9755_INVERT_CD;
+	if (of_property_read_bool(pdev->dev.of_node, "wp-inverted"))
+		value |= PCI_GLI_9755_INVERT_WP;
 	value &= ~PCI_GLI_9755_LFCLK;
 	value &= ~PCI_GLI_9755_DMACLK;
 	pci_write_config_dword(pdev, PCI_GLI_9755_PECONF, value);
Signature · 1 line
2.33.0
#2 lore raw

PATCH v3 2/2 mmc: sdhci-pci-gli: GL975[50]: Issue 8/16-bit MMIO reads as 32-bit reads.

In reply to Hector Martin

For some reason, <32-bit reads do not work on Apple ARM64 platforms with these chips (even though they do on other PCIe devices). Issue them as 32-bit reads instead. This is done unconditionally, as it shouldn't hurt even if not necessary.

---
 drivers/mmc/host/sdhci-pci-gli.c | 23 +++++++++++++++++++++++
 1 file changed, 23 insertions(+)
drivers/mmc/host/sdhci-pci-gli.c +23 -0
index ad50f16658fe..97035d77c18c 100644
@@ -902,7 +902,28 @@ static int gli_probe_slot_gl9763e(struct sdhci_pci_slot *slot)
 	return 0;
 }
 
+#define REG_OFFSET_IN_BITS(reg) ((reg) << 3 & 0x18)
+
+static u16 sdhci_gli_readw(struct sdhci_host *host, int reg)
+{
+	u32 val = readl(host->ioaddr + (reg & ~3));
+	u16 word;
+
+	word = (val >> REG_OFFSET_IN_BITS(reg)) & 0xffff;
+	return word;
+}
+
+static u8 sdhci_gli_readb(struct sdhci_host *host, int reg)
+{
+	u32 val = readl(host->ioaddr + (reg & ~3));
+	u8 byte = (val >> REG_OFFSET_IN_BITS(reg)) & 0xff;
+
+	return byte;
+}
+
 static const struct sdhci_ops sdhci_gl9755_ops = {
+	.read_w			= sdhci_gli_readw,
+	.read_b			= sdhci_gli_readb,
 	.set_clock		= sdhci_gl9755_set_clock,
 	.enable_dma		= sdhci_pci_enable_dma,
 	.set_bus_width		= sdhci_set_bus_width,
@@ -922,6 +943,8 @@ const struct sdhci_pci_fixes sdhci_gl9755 = {
 };
 
 static const struct sdhci_ops sdhci_gl9750_ops = {
+	.read_w			= sdhci_gli_readw,
+	.read_b			= sdhci_gli_readb,
 	.read_l                 = sdhci_gl9750_readl,
 	.set_clock		= sdhci_gl9750_set_clock,
 	.enable_dma		= sdhci_pci_enable_dma,
Signature · 1 line
2.33.0
#3 lore raw
In reply to Hector Martin
Quoted 16 lines · Hector Martin

Hi folks,

This short series adds a few quirks needed to make the card readers in Apple M1 Pro/Max MacBook laptops work properly.

The first patch should be straightforward; it just allows configuring the CD/WP polarity based on device tree settings. There is already a standard DT binding for this.

The second patch works around an issue with 8/16-bit MMIO reads that only affects these platforms, for some reason.

Changes since v2:
- Style fixes

Quoted 9 lines

Hector Martin (2):
mmc: sdhci-pci-gli: GL9755: Support for CD/WP inversion on OF
platforms
mmc: sdhci-pci-gli: GL975[50]: Issue 8/16-bit MMIO reads as 32-bit
reads.

 drivers/mmc/host/sdhci-pci-gli.c | 34 ++++++++++++++++++++++++++++++++
 1 file changed, 34 insertions(+)

Applied for next, thanks!

Kind regards
Uffe